Ryobi HP37 Manuel d'utilisateur télécharger pdf (Page 12)

12 — English

BATTERY PACK REMOVAL AND PREPARATION

FOR RECYCLING

See Figure 11.

TO REMOVE:

 Remove the three screws securing motor housing cover

then remove cover.

 Lift batteries from motor housing enough to expose leads

and battery terminals. Disconnect leads from battery

terminals. NOTE: Be careful not to break battery leads

when disconnecting them.

To preserve natural resources, please recycle or

dispose of batteries properly.

This product uses nickel-cadmium batteries.

Local, state or federal laws may prohibit disposal

of nickel-cadmium batteries in ordinary trash.

Consult your local waste authority for information regarding

available recycling and/or disposal options.

WARNING:

Upon removal, cover the battery pack’s terminals with

heavy-duty adhesive tape. Do not attempt to destroy

or disassemble battery pack or remove any of its com-

ponents. Nickel-cadmium batteries must be recycled or

disposed of properly. Also, never touch both terminals

with metal objects and/or body parts as short circuit may

result. Keep away from children. Failure to comply with

these warnings could result in fire and/or serious injury.

MAINTENANCE

Fig. 11

BATTERY

LEAD

BATTERIES

BATTERY

LEAD

MOTOR

HOUSING

COVER

SCREW(S)

BATTERY

TERMINALS

WARNING:

Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments

or accessories not recommended can result in serious personal injury.

ACCESSORIES

 No. 2 Phillips / 8-10 Slotted, 2 Ea.

 No. 3 Phillips / 6-8 Slotted, 2 Ea.

 5-Pc. Hex Shank Drill Bit Set

 6-Pc. Extra Length Magnite Power Bit Set

Look for these accessories where you purchased this product:

 7-Pc. Screwdriver Bit Set and Case

 13-Pc. Power Screwdriver/Nutdriver Set and Case

 17-Pc. Power Screwdriver/Nutdriver Set and Case

 30-Pc. Power Screwdriver/Nutdriver Set and Case

BULB REPLACEMENT

See Figure 12.

When purchasing replacement bulb, request recommended

part number 7802701.

 Turn the light OFF.

 To remove the bulb cover, press and slide it forward.

 Carefully lift out the bulb.

 Insert the new bulb between the two tabs and push it

securely into place.

 Slide the bulb cover back into position.

Fig. 12

BULB

COVER

TABS

BULB

TO INSTALL

REMOVE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi HP37 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Ryobi HP37