Ryobi AIRgrip Procross Laser level self leveling ELL0006 Manuel d'utilisateur télécharger pdf (Page 10)

OPERATION

ROUGH SURFACE ADAPTOR

See Figure 7.

By using the rough surface adaptor, you can use the AIRgrip

feature to position the unit on many non-smooth surfaces,

including brick and painted cinder block.

NOTE: The AIRgrip feature cannot be used with stucco or

unpainted cinder block.

Place the adaptor over the AIRgrip base.

Place the unit against the desired surface and press

slightly to engage the seal.

Continue to hold the unit against the surface while press-

ing the on/off button.

Slowly release the unit when you hear a change in motor

sound.

CAUTION:

Before releasing the unit, make sure the unit is securely

adhered to the surface.

USING THE MULTI-FUNCTION BASE

See Figures 8 - 9.

Hook-and-loop strap and push pin methods are available

when the multi-function base is installed. To install, snap the

base over the AIRgrip vacuum seal.

HOOK-AND-LOOP STRAP: The strap can be used to attach

the laser level to irregularly shaped objects such as pipes,

boards, or metal grates.

Attach the strap to the multi-function base by threading it

through the loops. The looped (or fuzzy) side of the strap

should face the base.

Position the laser level against the surface where you

want it mounted.

Wrap the strap around the object being mounted (pipe,

board, etc.) and pass the end of the strap through the

retaining loop. Pull to tighten.

Place the hooked end of the strap against the looped (or

fuzzy) side of the strap and press together to secure.

NOTE: To use the hook-and-loop strap to hang the unit from

overhead, use the loops on top of the laser level housing.

PUSH PINS: Push pins allow the laser level to be mounted

to stucco and permeable surfaces.

Place the laser level on the surface where you want it

mounted.

Align push pin with angled hole located on one side of

laser level base and push in to secure.

In the angled hole on the other side of laser level base,

secure the second push pin.

Fig. 9

Fig. 8

Fig. 7

1 2 ... 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi AIRgrip Procross Laser level self leveling ELL0006 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi AIRgrip Procross Laser level self leveling ELL0006