Ryobi AIRgrip Procross Laser level self leveling ELL0006 Manuel d'utilisateur télécharger pdf (Page 9)

OPERATION

Rotate the laser lens housing until the battery compart-

ment comes into view.

Remove battery cover plate.

Install two AA batteries according to polarity indicators

(+ or −) inside the battery compartment.

Reinstall the battery cover plate.

NOTE: Remove the batteries from both the vacuum base

and the laser if you will not be using the unit for an extended

time.

TURNING THE VACUUM BASE ON/OFF

See Figure 5.

Press the button located on the right side of the vacuum

base to turn it on and off. Always wait for at least 5 seconds

between stopping and restarting the unit.

USING THE AIRGRIP VACUUM

See Figure 5.

Vacuum grip technology allows the unit to be attached to

most smooth surfaces.

NOTE: The multi-function base is not used when mounting

by vacuum grip.

Place the unit on the surface you want it secured to and

press against the surface slightly to seal.

Continue to hold the unit against the surface while press-

ing the on/off button.

Slowly release the unit when you hear a change in motor

sound.

NOTE: Before releasing the unit, make sure the unit is

securely adhered to the surface.

NOTE: To release the vacuum seal, turn the power to the

vacuum base off. For fast release, press the vacuum release

button located on the left side of the unit. Pulling the unit

off the wall without releasing the vacuum could damage

the product.

To reposition the laser level while it is adhered to a sur-

face, depress the vacuum release button while allowing

the AIRgrip vacuum to continue running. This will release

the seal enough to allow you to slide the unit to a different

position.

TURNING THE LASER ON/OFF

See Figure 6.

Depressing the on/off button located on the top of the laser

level cycles the laser through three different operational

modes.

Depress the button once to turn on a horizontal laser

line.

Depress the button again to switch to a vertical line.

Depress the button a third time to switch to the crosshair

laser line.

Turn the laser off by depressing the button a fourth

time.

Fig. 4

Fig. 5

Fig. 6

LASER ON/OFF

BUTTON

LINE HEIGHT

ADJUSTMENT

KNOB

LASER LENS

HOUSING

BATTERy

COVER PLATE

ROTATIONAL

ADJUSTMENT

KNOB

AIRGRIP

VACUUM

ON/OFF

BUTTON

VACUUM

RELEASE

BUTTON

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi AIRgrip Procross Laser level self leveling ELL0006 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi AIRgrip Procross Laser level self leveling ELL0006