Ryobi cordless drill driver hp61 Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 14
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
Page 7
5
1
3
7
OPERATION
Fig. 3
WARNING:
If any parts are missing, do not operate tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
SWITCH
See Figure 3.
Your drill starts and stops by depressing and releasing the
switch trigger.
Your drill has a two-speed feature in the switch. Depress
the switch trigger halfway for driving screws at low speed.
Depress the switch trigger all the way for normal drilling.
Release the switch trigger to turn drill OFF.
SWITCH LOCK
See Figure 3.
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use. To lock the switch trigger, place the direction
of rotation selector in the center position.
DIRECTION
OF ROTATION
SELECTOR
SWITCH
TRIGGER
FORWARD
REVERSE
CENTER
POSITION (LOCK)
IMPORTANT INFORMATION FOR
RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries be-
come hot. You should let the batteries cool down for approxi-
mately 30 minutes before attempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger does not charge your batteries under normal circum-
stances, return both the drill-driver and charger to your
nearest AUTHORIZED SERVICE CENTER for electrical
check.
For more information on the battery recycling call
1-800-8 BATTERY.
CAUTION:
Your drill contains special high temperature batteries to
help prevent battery damage when left on charge for
extended periods of time. However, once the batteries
become fully charged, we recommend that you unplug
your charger from power supply and disconnect it from
drill.
REVERSIBLE
See Figure 3.
This tool is reversible. The direction of rotation is controlled
by a selector located above the switch trigger. With the drill
held in normal operating position, the direction of rotation
selector should be positioned to the left of the switch for
drilling. The drilling direction is reversed when the selector is
to the right of the switch. When the selector is in center
position, the switch trigger is locked.
CAUTION:
To prevent gear damage, always allow chuck to come to
a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the chuck to come
to a complete stop.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be locked when not in use or when
carrying at your side.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire