Ryobi HP1442M Manuel d'utilisateur télécharger pdf (Page 11)

Page 11

OPERATION

WRONG

CHUCK JAWS

DRILL BIT

CHUCK COLLAR

CHUCK BODY

INSTALLING BITS

■ Place the direction of rotation selector in center position.

This will lock the switch trigger in the off position.

See

Figure 4.

■ Open or close the chuck jaws to a point where the opening

is slightly larger than the bit size you intend to use. Also,

raise the front of your drill slightly to keep the bit from

falling out of the chuck jaws.

■ Insert your drill bit into the chuck the full length of the jaws.

See Figure 8.

■ Tighten the chuck jaws on the drill bit. To tighten, grasp

and hold the collar of the chuck with one hand, while

rotating the chuck body with your other hand.

Note: Rotate the chuck body in the direction of the arrow

marked GRIP to tighten the chuck jaws.

■ DO NOT use a wrench to tighten or loosen the chuck

jaws.

WARNING:

Do not insert drill bit into chuck jaws and tighten as shown

in figure 9. This could cause drill bit to be thrown from

drill resulting in possible serious personal injury or

damage to the chuck.

REMOVING BITS

See Figure 8.

■ Place the direction of rotation selector in center position.

This will lock the switch trigger in the off position.

See

Figure 4.

■ Loosen the chuck jaws from drill bit

■ To loosen: grasp and hold the collar of the chuck with one

hand, while rotating chuck body with your other hand.

Note: Rotate chuck body in the direction of the arrow

marked RELEASE to loosen chuck jaws.

■ DO NOT use a wrench to tighten or loosen the chuck

jaws.

■ Remove drill bit from chuck jaws.

MAG TRAY™

See Figure 10.

For convenience, your drill has a Mag Tray™ to place small

parts when doing a variety of tasks.

RIGHT

Fig. 9

MAG TRAY™

(SCREW HOLDER)

Fig. 10

Fig. 8

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi HP1442M Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi HP1442M