Ryobi HP1442M Manuel d'utilisateur télécharger pdf (Page 4)

Page 4

SPECIFIC SAFETY RULES AND/OR SYMBOLS

WARNING:

Some dust created by power sanding, sawing, grinding,

drilling, and other construction activities contains chemi-

cals known to cause cancer, birth defects or other repro-

ductive harm. Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other

masonry products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on

how often you do this type of work. To reduce your

exposure to these chemicals: work in a well ventilated

area, and work with approved safety equipment, such as

those dust masks that are specially designed to filter out

microscopic particles.

WARNING:

A damaged battery is subject to explosion. To avoid

serious personal injury, properly dispose of a damaged

battery.

Important Safety Instructions For Charger

■ Save these instructions. This manual contains im-

portant safety and operating instructions for charger.

Following this rule will reduce the risk of electric shock,

fire, or serious personal injury.

■ Before using battery charger, read all instructions

and cautionary markings in this manual, on battery

charger, and product using battery charger. Follow-

ing this rule will reduce the risk of electric shock, fire, or

serious personal injury.

■ To reduce risk of injury, charge only nickel-cadmium

and nickel metal hydride type rechargeable batter-

ies. Other types of batteries may burst causing

personal injury and damage. Following this rule will

reduce the risk of electric shock, fire, or serious personal

injury.

■ Do not expose charger to wet or damp conditions.

Following this rule will reduce the risk of electric shock,

fire, or serious personal injury.

■ Use of an attachment not recommended or sold by

the battery charger manufacturer may result in a risk

of fire, electric shock, or injury to persons. Following

this rule will reduce the risk of electric shock, fire, or

serious personal injury.

■ To reduce risk of damage to charger body and cord,

pull by charger plug rather than cord when discon-

necting charger. Following this rule will reduce the risk

of electric shock, fire, or serious personal injury.

■ Make sure cord is located so that it will not be

stepped on, tripped over, or otherwise subjected to

damage or stress. Following this rule will reduce the risk

of serious personal injury.

■ An extension cord should not be used unless abso-

lutely necessary. Use of improper extension cord could

result in a risk of fire and electric shock. If extension cord

must be used, make sure:

a. That pins on plug of extension cord are the

same number, size and shape as those of

plug on charger.

b. That extension cord is properly wired and in

good electrical condition; and

c. That wire size is large enough for AC ampere

rating of charger as specified below:

Cord Length (Feet) 25' 50' 100'

Cord Size (AWG) 16 16 16

Note: AWG = American Wire Gage

■ Do not operate charger with a damaged cord or plug.

If damaged, have replaced immediately by a qualified

serviceman. Following this rule will reduce the risk of

electric shock, fire, or serious personal injury.

■ Do not operate charger if it has received a sharp

blow, been dropped, or otherwise damaged in any

way; take it to a qualified serviceman. Following this

rule will reduce the risk of electric shock, fire, or serious

personal injury.

■ Do not disassemble charger; take it to a qualified

serviceman when service or repair is required. Incor-

rect reassembly may result in a risk of electric shock

or fire. Following this rule will reduce the risk of electric

shock, fire, or serious personal injury.

■ To reduce the risk of electric shock, unplug charger

from outlet before attempting any maintenance or

cleaning. Turning off controls will not reduce this

risk. Following this rule will reduce the risk of electric

shock, fire, or serious personal injury.

■ Disconnect charger from power supply when not in

use. Following this rule will reduce the risk of electric

shock, fire, or serious personal injury.

DANGER:

RISK OF ELECTRIC SHOCK. DO NOT TOUCH

UNINSULATED PORTION OF OUTPUT CONNECTOR

OR UNINSULATED BATTERY TERMINAL.

■ Save these instructions. Refer to them frequently

and use them to instruct others who may use this

tool. If you loan someone this tool, loan them these

instructions also. Following this rule will reduce the risk

of electric shock, fire, or serious personal injury.

1 2 3 4 5 6 7 8 9 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi HP1442M Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi HP1442M