Page 6
FEATURES
PRODUCT SPECIFICATIONS:
DRILL-DRIVER HP1442M HP1802M
Chuck 3/8 in. Keyless 1/2 in. Keyless
Motor DC Motor 14.4 Volt DC Motor 18 Volt
Gear Train Two Speed Two Speed
Switch Variable Speed Variable Speed
No Load Speed 0-330 RPM (Low) 0-350 RPM (Low)
0-1100 RPM (High) 0-1300 RPM (High)
Clutch 24 Positions 24 Positions
Charger Input 120 V, 60 Hz, AC only 120 V, 60 Hz, AC only
Charge Rate 1 Hour 1 Hour
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
WARNING:
Carefully read through this entire operator's manual before
using your new drill-driver. Pay close attention to all Safety
Rules, Warnings and Cautions. If you use your drill-driver
properly and only for what it is intended, you will enjoy years
of safe, reliable service.
WARNING:
Do not allow familiarity with your drill-driver to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
KEYLESS CHUCK
Your drill-driver has a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
TWO SPEED GEAR TRAIN
Your drill has a two-speed gear train designed for drilling or
driving at LO (1) or HI (2) speeds. A slide switch is located
on top of your drill to select either LO (1) or HI (2) speed.
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse selector located above
the switch trigger.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the top of the motor
housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top and end of the motor housing.
The operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always
wear safety goggles or safety glasses with side shields and a full face shield when needed.
We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety
glasses with side shields. Always use eye protection which is marked to comply with ANSI
Z87.1.
WARNING:
(14 pages)
(34 pages)
(50 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels