Ryobi HP1442M Manuel d'utilisateur télécharger pdf (Page 8)

Page 8

OPERATION

Fig. 2

WARNING:

If any parts are missing, do not operate tool until the

missing parts are replaced. Failure to do so could result

in possible serious personal injury.

LED FUNCTION OF CHARGER

See Figure 2.

LED WILL BE LIGHTED TO INDICATE STATUS OF

CHARGER AND BATTERY PACK:

■ Red LED lighted = Fast Charging Mode

■ Green LED lighted = Fully Charged Battery Pack

■ Yellow and Green LED Lighted = Control Charge or

Defective Battery Pack.

CHARGING YOUR DRILL-DRIVER

The battery pack for this tool has been shipped in a low

charge condition to prevent possible problems. Therefore,

you should charge it prior to use.

Note: Batteries will not reach full charge the first time they

are charged. Allow several cycles (drilling followed by re-

charging) for them to fully charge.

TO CHARGE

■ Charge battery pack only with the charger provided.

■ Make sure power supply is normal house voltage,

120 volts, 60 Hz, AC only.

■ Connect charger to power supply.

■ Place battery pack in charger.

See Figure 3.

Align raised

rib on battery pack with groove in charger.

■ Press down on battery pack to be sure contacts on

battery pack engage properly with contacts in charger.

When properly connected, red light will turn on.

■ Normally, the yellow and green lights on the charger will

come on. This indicates charger is in control charge

mode and should switch to fast charge mode within 5

minutes. When charger is in fast charge mode the red

light will come on. If after a period of 15 minutes the

yellow and green lights remain on, remove the battery

pack, wait 1 minute and reinsert battery pack in charger.

If the yellow and green lights continue to remain on an

additional 15 minutes, the battery pack is damaged and

will not accept charge.

■ When your battery pack becomes fully charged, the red

light will turn off and the green light will turn on.

■ After normal usage, 1 hour of charge time is required to

be fully charged. A minimum charge time of 1 to 1-1/2

hours is required to recharge a completely discharged

tool.

■ The battery pack will become slightly warm to the touch

while charging. This is normal and does not indicate a

problem.

■ DO NOT place charger in an area of extreme heat or

cold. It will work best at normal room temperature.

BATTERY

CHARGER

GREEN LIGHT "ON"

INDICATES FULLY

CHARGED

YELLOW AND GREEN LIGHTS "ON"

INDICATES CONTROL CHARGE OR

POSSIBLE FAULTY BATTERY

RED LIGHT "ON"

INDICATES FAST

CHARGING MODE

Fig. 3

BATTERY

PACK

BATTERY

CHARGER

IMPORTANT INFORMATION FOR RECHARGING

HOT BATTERIES

When using your drill-driver continuously, the batteries in

your battery pack become hot. You should let a hot battery

pack cool down for approximately 30 minutes before at-

tempting to recharge.

Note: This situation occurs when continuous use of your

drill-driver causes the batteries to become hot. It does not

occur under normal circumstances. Refer to "Charging

Your Drill-Driver" for normal recharging of batteries. If the

charger/charging assembly does not charge your battery

pack under normal circumstances, return both the battery

pack and charger/charging assembly to your nearest Ryobi

Authorized Service Center for electrical check.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi HP1442M Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi HP1442M