Ryobi P320 Manuel d'utilisateur télécharger pdf

FIGURE 1

Under some conditions, the unit may not deliver

a nail when the air pressure dial is turned to the

MAXIMUM pressure setting. The user may need to

decrease the pressure setting for desired operation.

(Refer to Setting the Air Pressure in the operator’s

manual page 9.)

FIGURE 2

NOTICE:

Remove battery pack before performing any of

the steps described below.

Driving too deeply into the material, excess debris, or

jammed nails may lead to a driver blade being stuck

at its bottom position.

The driver blade can usually be returned to its

operating position by depressing the work contact

element against a scrap piece of wood and squeezing

the trigger.

If this does not automatically return the drive blade

into the tool, remove the battery and refer to the

figure 2 and instructions in the operators manual on

removing a jammed nail.

(Refer to Removing a Jammed Brad Nail in the

operator’s manual page 10.)

990000552

2-21-13 (REV:01)

OPERATOR’S MANUAL

ADDENDUM

P320

Fig. 1

Fig. 2

A - Air pressure dial (cadran de pression d’air, cuadrante de

presión de aire)

B - Index arrow (flèche repère, flecha indicadora)

C - Decrease pressure (réduire la pression, disminuir la presión)

D - Increase pressure (augmenter la pression, aumentar la

presión)

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625

USA

1-800-525-2579 • www.ryobitools.com

A subsidiary of Techtronic Industries Co., Ltd.

OTC: TTNDY

A - Screwdriver (tournevis, destornillador)

B - Latch (loquet, pestillo)

C - Jam release (déblocage, soltador)

D - Driver blade (lame d’entraînement, hoja de empuje)

For Ryobi Customer Service

call 1-800-525-2579.

1 2

Résumé du contenu

Page 1 - ADDENDUM

123FIGURE 1Under some conditions, the unit may not deliver a nail when the air pressure dial is turned to the MAXIMUM pressure setting. The user may n

Page 2 - OPERADOR

FIGURE 1Sous certaines conditions, il est possible que l’outil ne tire pas de clou si le cadran de pression d’air est tourné vers le réglage de pressi