Ryobi P635 Manuel d'utilisateur télécharger pdf (Page 10)

10 — English

OPERATION



Chest strap should be tightened or loosened until adjusted

to a comfortable operating position.





Waist strap should be tightened or loosened until adjusted

to a comfortable operating position.

WARNING:

To reduce the risk of injection, do not point sprayer at

any part of the body or person. In case of skin injection,

seek medical attention immediately. Do not use without

spray tip in place.



See Figures 10 - 12, page 16, and 18 - 19, page 17.

 Place a line of lubricant on the piston. To gain access to

the piston, follow the instructions in Cleaning the Unit

for Storage in the Maintenance section of this manual.

 Ensure surface to be painted is free of dust, dirt, and

grease.

 Mask or cover any areas not intended to be painted or

stained. Be aware of wind that may cause your paint or

stain to spray into areas not desired. Always use drop

cloths or other cover to protect areas that are not intended

to be painted or stained.

 Fill the backpack tank with no more than 1.5 gallons of

paint or stain.

NOTE: After every refill of the tank, add a line of lubricant

to the piston. See Cleaning the Unit for Storage for

instructions on disassembling the sprayer to gain access

to the piston.

 Select the proper spray tip for desired spray pattern. See

Selecting the Proper Spray Tip.

 Install the battery pack in the backpack unit.

 Connect the paint supply tube to both the backpack unit

and the sprayer.

 Prime the backpack unit:

• Place the motor switch in the forward position.

• Aim into a bucket and squeeze the trigger on the

sprayer to release air inside the unit.

• Once paint is running through both the intake tube and

the return tube, the unit is primed.

• Place the motor switch in the off position.

 Connect the DC power cord of the sprayer into the outlet

on the backpack unit.

 Place the motor switch in the forward position.

 Pull the switch trigger to spray paint. Release the switch

trigger to stop paint spray.

 Practice spraying on a piece of scrap material to test your

spray pattern and to prime the pump before beginning. If

you cannot get a good spray pattern with an even amount

of paint or stain throughout, refer to the 

section later in this manual.

NOTE: The pump must be primed after every paint

change and at first use after storing. Spray paint at a

scrap surface for at least 20 seconds to prime.

To create an even coating over the entire surface:

• Move your arm at a steady rate of speed and make

sure to move your entire arm, not just your wrist.

• Keep the sprayer an even distance from the area being

sprayed, which should be between 8 to 10 inches from

the tip of the sprayer to the surface being sprayed.

• Depress the trigger to begin the spray off the mate-

rial you want to paint. Operate the sprayer in straight

horizontal or vertical strokes across the surface being

painted, then release the trigger off the material to end

the stroke.

NOTE: For spray quality consistency when using thin-

ner paints, it may be necessary to keep the trigger

depressed between strokes.

When finished, disconnect the DC power cord, then

place the motor switch in the reverse position to allow

unused paint to return to the backpack tank. Then remove

the battery pack, return any unused paint or stain to its

original container, and thoroughly clean the sprayer.

CAUTION:

It is important to thoroughly clean the unit after each

use or when changing colors. Allowing paint or stain to

remain in an idle tool for an extended period can cause

its moving pieces and connectors to seize up.

WARNING:

Do not clean with any flammable liquids such as paint

stripper, paint remover, brush cleaner, mineral spirits,

lacquer thinner, turpentine, acetone, gasoline, kerosene,

etc.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi P635 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi P635