Ryobi P635 Manuel d'utilisateur télécharger pdf (Page 8)

14 — English



PROBLEM CAUSE POSSIBLE SOLUTION

Motor does not run. Battery is not charged. Charge battery.

Motor overheats. Piston has seized up.

Continuous spray operation.

Thoroughly clean the sprayer using long-

term storage cleaning instructions in the

Maintenance section of this manual.

Release trigger at the end of each pass to

allow the motor to cool.

Motor has a low hum but does not

spray.

Piston has seized up. Thoroughly clean the sprayer using long-

term storage cleaning instructions in the

Maintenance section of this manual.

Motor seems to be running properly

but doesn’t spray.

Suction tube and filter are loose or

damaged.

Atomizer valve is clogged or worn

out.

Material being sprayed is too thick.

Plugged spray tip or intake filter;

worn piston.

Reinstall or replace suction tube and filter

as needed.

Clean or replace atomizer valve.

Follow material manufacturer’s directions

and thin material as needed.

Thoroughly clean the sprayer and, if

necessary, replace piston*, using storage

cleaning instructions in the Maintenance

section of this manual.

Unit will not prime. Paint supply tube is kinked.

Air is trapped in the sprayer or roller.

Pull slightly on the paint supply tube to

release the kink.

Attach paint supply tube and roller or

sprayer. Depress trigger on roller or

sprayer to release trapped air.

Sprayed material is spitting or glob-

bing up.

Paint container volume is getting low.

Material being sprayed is too thick.

Suction tube is loose.

Atomizer valve is clogged or worn

out.

Worn spray tip or piston.

Refill paint container.

Follow material manufacturer’s directions

to thin material as needed.

Reinstall suction tube securely.

Clean or replace atomizer valve.

Clean or replace spray tip or piston*.

Paint/stain spray overspray is exces-

sive.

Spray tip is too far from the surface

being sprayed.

Hold sprayer closer to the surface being

sprayed.

Paint/stain runs or sags on the work

surface.

Proper paint methods not being ob-

served.

Refer to Operating the Sprayer earlier in

this manual.

Paint/stain is leaking behind the spray

tip.

Spray tip is loose.

Atomizer valve is worn or not posi-

tioned properly.

Tighten spray tip.

Replace or reposition atomizer valve as

needed.

* Although unlikely, a worn piston is possible. A replacement piston can be purchased by calling customer service at

1-800-525-2579. Follow the instructions in Cleaning the Unit for Storage to access the piston for replacement.





1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Ryobi P635 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi P635