Ryobi RY30931 Manuel d'utilisateur télécharger pdf (Page 12)

ATTACHING THE FRONT HANDLE - CS30 AND

SS30

See Figure 4.

 Remove wing nut, washer, and bolt from the front

handle.

 Install the front handle onto the top side of the drive shaft

housing in the area indicated by the label.

NOTE: The open side of the handle should face the

operator.

 Place the bolt through the front handle.

NOTE: The hex bolt head fits inside the hex recess molded

into one side of the handle.

 Reinstall the washer and wing nut.

 Tighten wing nut securely.

ATTACHING THE “J” HANDLE - BC30

See Figure 5.

A “J” handle must be used for ensuring the best control and

maximizing operator safety when using a brushcutter.

 Hold the top and bottom clamp snugly in position on

the shaft housing so that handle will be located to the

operator’s left.

 Insert the end of the handle between the clamps.

 Align the bolt holes and push the long bolt (1/4-20 x

1-1/2 in.) through the handle side.

 Place short bolt (1/4-20 x 1 in.) through opposite side of

clamp. Install flat washers, lock washers, and hex nuts

to hold the assembly in place.

 After assembly is complete, adjust the position of the

handle to the area indicated by the label on the drive

shaft housing.

 Tighten first the long bolt and then the short bolt.

ASSEMBLY

WING

NUT

FRONT HANDLE

BOLT

Fig. 4

Fig. 5

CLAMP

FLAT WASHER

LOCK WASHER

HEX NUT

STRAP

HANGER

BOLT

1/4-20 x 1-1/2 in.

CLAMP

FRONT

HANDLE

BOLT

1/4-20 x 1 in.

WASHER

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY30931 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi RY30931