Ryobi RY30931 Manuel d'utilisateur télécharger pdf (Page 22)

MAINTENANCE

Fig. 26

INSTALLING STRING IN REEL EASY STRING

HEAD

See Figures 26 - 27.

Use .095 in. diameter monofilament string.

Stop the engine and disconnect the spark plug wire.

Cut one piece of string approximately 25 ft. in length.

Rotate knob on string head until line on knob aligns with

arrows on top of string head.

Insert one end of string into eyelet located on the side of

the string head and push until string comes out through

eyelet on the other side. Continue to push string through

the string head until the middle section of the string is

inside the string head and string outside the string head

is evenly divided on each side.

Rotate the knob on the string head to wind the string. If

using the CS30, knob should be rotated counterclock-

wise. If using the SS30 or the BC30, knob should be

rotated clockwise. Wind the string until approximately

8 in. remains protruding from the string head.

INSTALLING PRO CUT II STRING HEAD

See Figure 28.

Stop the engine and disconnect the spark plug wire.

Remove currently installed string head.

Install the string head on the drive shaft until fully seat-

ed.

Install the spool retainer and turn counterclockwise for

CS30 or clockwise for SS30 or BC30 to secure.

Install string as described in the next section of this

manual.

Fig. 27

SPOOL

RETAINER

STRING

HEAD

DRIVE SHAFT

Fig. 28

ALIGN

LINE ON

KNOB WITH

ARROWS

INSERT

STRING TO

CENTER

AND ROTATE

KNOB TO

WIND

EYELET

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY30931 Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi RY30931