Ryobi P715 Manuel de l'opérateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 10
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
9
MAINTENANCE
BULB
ASSEMBLY
Fig. 7
RETAINER
PIN
CAUTION:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.
REPLACEMENT FUSE
See Figure 8.
If the spotlight blows its fuse, you will need to replace it. Look
for replacement fuses where you purchased this product.
Remove the battery pack from the spotlight to access
fuse housing.
Remove the current fuse and discard. Use a pair of
fuse pullers if necessary.
Use 10 amp JAT blade type automotive fuse to replace
the blown fuse.
NOTE: Only use 10 amp JAT blade type automotive fuses
for replacement. If second fuse blows, return to authorized
service center for repair. Always ask for replacement fuse
number 019020001013.
BATTERIES
This product will accept 18 V lithium-ion batteries or 18 V
nickel-cadmium batteries. Length of service from each
charging will depend on the type of work you are doing.
The batteries for this product have been designed to provide
maximum trouble-free life. However, like all batteries, they
will eventually wear out. Do not disassemble battery pack
and attempt to replace the batteries. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
For lithium-ion batteries:
Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below
80°F and away from moisture.
Store battery packs in a 30%-50% charged condition.
Every six months of storage, charge the pack as
normal.
For nickel-cadmium batteries:
Remove the battery pack from the charger once it is fully
charged and ready for use.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below
80°F.
Store battery packs in a “discharged” condition.
Fig. 8
FUSE
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please
re c ycle or dispos e of batt eries
properly.
This product uses nickel-cadmium and
lithium-ion batteries. Local, state or
federal laws may prohibit disposal of
batteries in ordinary trash.
Consult your local waste authority for
information regarding available recycling
and/or disposal options.
WARNING:
Upon removal, cover the battery pack’s terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion and nickel-cadmium batteries must
be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
Li - Ion
GOOD FUSE
BLOWN FUSE
Vue de la page 8
1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire