Ryobi P715 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8 — English
MAINTENANCE
REPLACING BULBS
See Figures 4 - 6, page 8.
Over time, the bulb will burn out. When this occurs, replacing
the bulb will be necessary. Be careful not to touch the bulb
glass. This will reduce the life of the bulb.
To replace a bulb:
Remove battery from the spotlight and let it cool for at
least 5 minutes.
Turn the bezel counterclockwise to remove.
Remove the reflector assembly from the spotlight housing.
Do not pull on the leads connected to the assembly.
Remove the white connection point from its nest in the
housing.
Remove the white connection terminal from its connection
point.
NOTE: Do not pull white lead without holding the
connection point, as this may damage lead.
Remove the retainer pin from the reflector and remove
bulb assembly. Bulb assembly may be rotated in reflector
if needed to aid in removal.
Install new bulb assembly.
Replace bulb retainer pin.
Hold white connection terminal and reconnect white
lead.
Return the white connection point to its nest.
Align tabs on each side of lens seal with notches on
spotlight housing and seat lens seal in place.
Reattach bezel carefully by rotating clockwise.
Tighten securely.
NOTE: Always ask for replacement bulb H3 6V55W,
number 019020001007.
CAUTION:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.
REPLACEMENT FUSE
See Figure 7, page 8.
If the spotlight blows its fuse, you will need to replace it. Look
for replacement fuses where you purchased this product.
Remove the battery pack from the spotlight to access
fuse housing.
Remove the current fuse and discard. Use a pair of
fuse pullers if necessary.
Use 10 amp JAT blade type automotive fuse to replace
the blown fuse.
NOTE: Only use 10 amp JAT blade type automotive fuses
for replacement. If second fuse blows, return to authorized
service center for repair. Always ask for replacement fuse
number 019020001013.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
WARNING:
Upon removal, cover the battery pack’s terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Lithium-ion and nickel-cadmium batteries must
be recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts as
short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/
or serious injury.
NOTE: RECYCLING INFORMATION AND FIGURES (ILLUSTRATIONS) START ON
PAGE 8 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Commentaires sur ces manuels

Pas de commentaire