Ryobi P100 Manuel d'utilisateur télécharger pdf (Page 2)

Fig. 1

BATTERY

PACK

P110

CHARGER

BATTERIES

The battery pack is equipped with nickel-cadmium recharge-

able batteries. Length of service from each charging will

depend on the type of work you are doing.

The batteries have been designed to provide maximum

trouble-free life. However, like all batteries, they will eventually

wear out. Do not disassemble battery pack and attempt to

replace the batteries. Handling of these batteries, especially

when wearing rings and jewelry, could result in a serious burn.

To obtain the longest possible battery life, we suggest the

following:

 Remove the battery pack from the charger once it is fully

charged and ready for use.

For battery storage longer than 30 days:

 Store the battery pack where the temperature is below

80°F and away from moisture.

 Store battery packs in a 30%-50% charged condition.

 Every six months, charge the pack as normal.

BATTERY PACK REMOVAL AND

PREPARATION FOR RECYCLING

To preserve natural resources, please recycle or

dispose of batteries properly.

This product contains nickel- cadmium batteries.

Local, state or federal laws may prohibit disposal

of nickel- cadmium batteries in ordinary trash.

Consult your local waste authority for information regarding

available recycling and/or disposal options.

WARNING:

Upon removal, cover the battery pack’s termi-

nals with heavy-duty adhesive tape. Do not at-

tempt to destroy or disassemble battery pack or

remove any of its components. Nickel-cadmium

batteries must be recycled or disposed of properly. Also,

never touch both terminals with metal objects and/or

body parts as short circuit may result. Keep away from

children. Failure to comply with these warnings could

result in fire and/or serious injury.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge

them before first use.

If the charger does not charge the battery pack under normal

circumstances, return both the battery pack and charger to

your nearest Authorized Service Center for electrical check.

 Use battery pack only with the recommended charger

 Connect the charger to the power supply. For a complete

list of approved power sources, refer to the operator’s

manual for the charger.

Place the battery pack in the charger aligning raised rib

on the battery pack with the groove in the charger.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

 Do not place the charger and battery pack in an area of

extreme heat or cold. They will work best at normal room

temperature.

NOTE: The charger and battery pack should be placed

in a location where the temperature is more than 50°F

but less than 100°F.

 The battery pack will become slightly warm to the touch

while charging. This is normal and does not indicate a

problem.

When batteries become fully charged, unplug the charger

from power supply and remove the battery pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack cool

down before attempting to recharge.

NOTE: This situation only occurs when continuous use of a

tool causes the batteries to become hot. It does not occur

under normal circumstances. Refer to “CHARGING THE

BATTERY PACK” for normal recharging of batteries. If the

charger does not charge your battery pack under normal

circumstances, return both the battery pack and charger to

your nearest Authorized Service Center for electrical check.

SAVE THESE INSTRUCTIONS

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

Phone 1-800-525-2579

www.ryobitools.com

RYOBI is a registered trademark of Ryobi Limited and is used pursuant

to a license granted by Ryobi Limited.

OPERATION

1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire

Ryobi P100 Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Ryobi P100