Ryobi A113TS2 Manuel d'utilisateur télécharger pdf

English

WARNING:

To reduce the risk of injury, do not attempt to use this

product until you have read thoroughly and understand

completely this Operator’s Manual and the Operator’s

Manual for the Tile Saw.

UNPACKING

This product requires assembly.

n Carefully remove the product from the box. Make sure

that all items listed in the packing list are included.

WARNING:

Do not use this product if any parts on the Loose Parts List

are already assembled to your product when you unpack

it. Parts on this list are not assembled to the product by

the manufacturer and require customer installation. Use

of a product that may have been improperly assembled

could result in serious personal injury.

n Inspect the product carefully to make sure no breakage

or damage occurred during shipping.

n Do not discard the packing material until you have

carefully inspected and satisfactorily operated the

product.

n If any parts are damaged or missing, please call

1-800-525-2579 for assistance.

WARNING:

If any parts are damaged or missing do not operate this

tool until the parts are replaced. Use of this product

with damaged or missing parts could result in serious

personal injury.

LOOSE PARTS LIST

See Figure 1.

TOOLS NEEDED

See Figure 2.

ASSEMBLING THE STAND

See Figures 3 - 7.

nLay outside support bracket, on a flat surface. Place inside

support bracket on top of outside support bracket with

the top rails facing each other, as shown.

nInsert stand legs into the support brackets. Angled ends

of stand legs should face away from each other so they

resemble a “V”. Align holes for hardware.

nPlace hinge A between leg assembly on right side. Repeat

with hinge B on left side.

nCarefully align holes in legs and hinge. Install hardware

through holes as shown.

nUsing wrenches, tighten hardware securely.

nPlace stand on level ground and line up rails under tile

saw table with brackets on stand. Position tile saw onto

stand.

nBe sure the tile saw is on level ground and the stand is

sturdy before use.

CALIFORNIA PROPOSITION 65

WARNING:

This product may contain chemicals, including lead,

known to the State of California to cause cancer, birth

defects or other reproductive harm. Wash hands after

handling.

990000891

4-14-14 (REV:01)

OPERATOR’S MANUAL

TILE SAW STAND

A113TS2

FOR USE ONLY WITH THE RYOBI WS722 TILE SAW

This product has a Three-year Limited Warranty.

For Warranty details go to www.ryobitools.com

SAVE THESE INSTRUCTIONS

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road, Anderson, SC 29625

Phone 1-800-525-2579

www.ryobitools.com

1 2 3 4

Résumé du contenu

Page 1 - TILE SAW STAND

EnglishWARNING: To reduce the risk of injury, do not attempt to use this product until you have read thoroughly and understand completely this Operato

Page 2 - MANUEL D’UTILISATION

LISTE DES PIÈCES DÉTACHÉESVoir le figure 1.OUTILS NÉCESSAIRESVoir le figure 2.ASSEMBLAGE DU SUPPORTVoir les figures 3 à 7.nDéployer la ferrure de sup

Page 3 - MANUAL DEL OPERADOR

ADVERTENCIA:Para reducir el riesgo de lesiones, no intente usar este producto hasta que haya leído y comprendido totalmente este manual del operador y

Page 4

Fig. 3Fig. 4Fig. 2Fig. 5Fig. 6Fig. 7Fig. 1A - Support bracket (outside) [ferrure de support « extérieur », placa de soporte (exterior)]B - Support br