Ryobi RYI1000 Manuel d'utilisateur télécharger pdf (Page 22)

18 — English

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

Engine will not start. On/Off switch is OFF (O).

No fuel.

Stale gasoline or water in gasoline.

Lubricant level is low.

Spark plug faulty, fouled, or improperly

gapped.

Choke lever is in RUN position.

Engine stored without treating or

draining gasoline, or refueled with bad

gasoline.

Dirty fuel filter.

Turn On/Off switch to ON (I).

Fill fuel tank.

Drain entire system and refill with fresh

fuel.

Engine is equipped with Low Oil Shutoff.

If engine lubricant level is low, it must be

filled before unit will start. Check engine

lubricant level and fill, if necessary.

Replace spark plug.

Put the choke lever in the START

position.

Drain fuel and carburetor. Refuel with

fresh gasoline.

Contact authorized service center.

Engine hard to start Water in gasoline.

Weak spark at spark plug.

Drain entire system and refill with fresh

fuel.

Contact authorized service center.

Engine lacks power. Dirty air filter.

Engine stored without treating or

draining gasoline, or refueled with bad

gasoline.

Check air filter. Clean or replace as

needed.

Drain fuel and carburetor. Refuel with

fresh gasoline.

AC receptacle does not work. Generator is overloaded.

Item plugged in is defective.

Turn the generator off and remove all

loads. Restart the unit.

Try a different item.

DC receptacle does not work. Circuit protector engaged

Item plugged in is defective.

Remove any load from the generator.

Turn the auto idle switch to off, then

depress the DC circuit breaker.

Try a different item.

Generator makes a “spark knock” or

“pinging” noise.

An occasional light “knocking” or “ping-

ing” under heavy load is not a cause

for concern. However, if the knocking

or pinging occurs under normal load

at a steady engine speed, the problem

may be with the brand of gasoline be-

ing used.

Switch to a different brand of gasoline,

making sure that the octane rating is 86

or higher. If problem continues, contact

your nearest authorized service center.

If problem persists after trying the above solutions, contact your nearest authorized service center for assistance.

The following symptoms may indicate problems that will affect the emissions level of the unit:

Hard starting or stalling after starting

Rough idle

Misfiring or backfiring under load

Afterburning (backfiring)

Black exhaust smoke or high fuel consumption

If you encounter any of these symptoms, have the unit inspected and repaired by the nearest authorized service center.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ryobi RYI1000 Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Ryobi RYI1000