Ryobi RB100 Manuel de l'opérateur télécharger pdf (Page 8)

Page 8

APPLY POLISH TO THE APPLICATION BONNET

Most polishes are either in paste or liquid form. Before using

any polish read all directions on appropriate applications and

proper use.

FOR PASTE

See Figure 3.

Use a putty knife or other flat, blunt object to apply

approximately one rounded teaspoon of paste onto the

bonnet. Evenly spread the paste over the entire surface of the

bonnet.

Do not apply paste directly to the surface being polished.

PREPARE THE SURFACE

For best results, the surface should be clean and dry. Most

high-gloss surfaces can be cleaned with a mild soap and

water solution. For removal of stubborn dirt such as road tar,

grease, and bug stains, you can use a mild ammonia solution

such as that used in glass cleaners. Before using any

cleaning product, check the label for recommended

applications and follow the directions for use.

Never apply cleaner directly onto surface to be polished.

Apply to a clean cloth then use the cloth to clean the

surface.

Do not use any type of abrasive cleanser as it may

damage or scratch the surface.

WARNING:

Before connecting your buffer/polisher to power source,

always check to make sure the switch is not in ON position.

Failure to do so could result in accidental starting of your

buffer/polisher resulting in possible serious injury.

ATTACH THE APPLICATION BONNET

See Figure 2.

WARNING:

To avoid injury, always make sure the buffer/polisher is

unplugged before attaching bonnets.

Your Ryobi buffer/polisher comes with two bonnets, one for

applying the polish to the surface and the other for buffing the

surface. Both are fitted with a drawstring. The application

bonnet is the one made of terrycloth.

To attach the application bonnet to the pad, loosen the

drawstring so that the bonnet fits completely over the pad.

Place the bonnet over the pad so that the outer edge can be

drawn over the top of the pad. Then carefully tighten the

drawstring around the pad and secure it with a simple

overhand knot. Tuck the drawstring inside the bonnet.

WARNING:

The drawstring must be tucked securely inside the bonnet

before turning the buffer/polisher on. Failure to do so could

result in the drawstring being caught between the motor

housing and orbiting pad, increasing the risk of serious

injury.

DRAWSTRING MUST BE

SECURELY TUCKED

INSIDE BONNET

Fig. 3

Fig. 4

Fig. 2

FOR LIQUID

See Figure 4.

Apply a small circle of liquid (about the size of a half-dollar)

around the center of the bonnet, followed by two more rings,

each slightly larger than the previous one. After the first

application, the bonnet will not absorb as much polish. So

apply just two rings, using half of the initial quantity.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Ryobi RB100 Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Ponceuses électriques Ryobi RB100