Ryobi BD4600 Manuel de l'opérateur télécharger pdf (Page 11)

4 x36

ADJUSTMENTS

WARNING:

Before performing any adjustment, make sure the belt/

disc sander is unplugged from the power supply and the

switch is in the OFF position. Failure to heed this warning

could result in serious personal injury.

ADJUSTING THE BELT TRACKING

See Figure 11.

■ Plug in belt/disc sander.

To check belt tracking:

■ Turn the switch ON and then immediately turn it OFF. If

the belt tends to slide off the idler drum or drive drum, the

belt is not tracking properly.

To adjust belt tracking:

■ If the sanding belt moves toward the disc, turn the tracking

knob clockwise 1/4 turn.

■ If the sanding belt moves away from the disc, turn the

tracking knob counterclockwise 1/4 turn.

■ Turn the switch ON and then immediately OFF again,

noting belt movement. Readjust tracking knob if

necessary.

SQUARING THE WORKTABLE TO THE

SANDING DISC

See Figure 12

■ Unplug the belt/disc sander.

■ Using a combination square, check the angle of the

worktable with the sanding belt.

■ If the worktable is not 90° with the disc, loosen the table

lock knob and tilt the table.

■ Adjust worktable square to the sanding disc and retighten

the table lock knob.

Note: Use the adjustment screw beneath the worktable

to move the table further or closer to the sanding disc.

WARNING:

Before attempting to use your belt/disc sander familiarize

yourself with all operating features and safety require-

ments.

LOCKING THE SWITCH

See Figure 13.

■ Place the switch in the OFF position.

■ Wait until the belt/disc sander has come to a full and

complete stop.

■ Remove the switch key from the switch assembly. Store

key in safe place.

WARNING:

Do not reach across the sanding disc to turn the belt/disc

sander ON or OFF. Contact with the sanding disc can

result in serious personal injury.

See Figure 13.

TRACKING

KNOB

Fig. 11

4 x36

SWITCH

Fig. 12

COMBINATION

SQUARE

TABLE

LOCK

KNOB

ON/OFF

SWITCH KEY

Fig. 13

ADJUSTMENT

SCREWS

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi BD4600 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BD4600