Ryobi R180 Manuel de l'opérateur télécharger pdf (Page 9)

Page 9

OPERATION

BASE

INDICATOR

POINT

DEPTH

INDICATOR

RING

CUTTER AT

ZERO DEPTH OF CUT

Fig. 6

FOR ROUTER TABLE USE ONLY

Fig. 7

Fig. 8

CUTTER EXTENDED BELOW SUBBASE

DEPTH OF CUT ADJUSTMENTS (Continued)

4. Position your router so that the cutter can extend below

the subbase for desired depth setting.

See Figure 7.

5. Turn the depth adjusting ring to obtain the desired

depth of cut. The distance the cutter moves can be

read on the depth adjusting ring. Each mark on the

depth adjusting ring indicates 1/64 inch (.4 mm) change

in depth setting. One indicator point is located on front

of the motor housing, the other one is located on the

base.

6. Lock clamping lever, securing depth adjusting ring to

motor housing and base.

DEPTH OF CUT ADJUSTMENTS WHEN

ROUTER IS MOUNTED TO A ROUTER TABLE

See Figure 8.

The depth of cut is readable from both sides of the depth

adjusting ring. There is a depth indicator ring and indicator

point on both sides of the depth adjusting ring. The bottom

ring is convenient when using your router mounted to a

router table. The indicator point on the base should also be

used when using your router mounted to a router table.

The depth indicator rings are identical parts. Therefore,

when you have your router mounted upside down on a

router table, you set depth of cut by reading the scale

differently. Set the cutter at zero depth of cut, rotate depth

indicator ring to desired depth of cut on the scale, then turn

depth adjusting ring back to zero depth of cut and lock

clamping lever securely.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi R180 Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi R180