Ryobi RE170VS Manuel de l'opérateur télécharger pdf (Page 17)

Page 17

MAINTENANCE

When electric tools are use on fiberglass boats, sports cars,

wallboard, spackling compounds, or plaster, it has been

found that they are subject to accelerated wear and possible

premature failure, as the fiberglass chips and grindings are

highly abrasive to bearings, brushes, commutators, etc.

Consequently, it is not recommended that this tool be used

for extended work on any fiberglass material, wallboard,

spackling compounds, or plaster. During any use on these

materials, it is extremely important that the tool is cleaned

frequently by blowing with an air jet.

WARNING:

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing dust.

If operation is dusty, also wear a dust mask.

WARNING:

When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product

damage.

GENERAL

Avoid using solvents when cleaning plastic parts. Most plastics

are susceptible to damage from various types of commercial

solvents and may be damaged by their use. Use clean cloths

to remove dirt, carbon dust, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc. come in contact

with plastic parts. They contain chemicals that can

damage, weaken, or destroy plastic.

PROPER CARE OF CUTTERS

Get faster and more accurate cutting results by keeping

cutters clean and sharp. Remove all accumulated pitch and

gum from cutters after each use.

When sharpening cutters, sharpen only the inside of the

cutting edge. Never grind the outside diameter. Be sure

when sharpening the end of a cutter to grind the clearance

angle the same as originally ground.

PROPER CARE OF COLLET

From time to time, it also becomes necessary to clean your

collet and collet nut. To do so, simply remove collet nut from

collet and clean the dust and chips that have collected. Then

return collet nut to its original position. Tighten collet nut on

collet without a cutter installed.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrication

is required.

OPERATION

Fig. 22

Fig. 23

5/16-18 X 3/4 IN.

FLATHEAD SCREW

#10-32 PAN HEAD

SCREW

SUBBASE

BASE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Commentaires sur ces manuels

Pas de commentaire

Ryobi RE170VS Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RE170VS