Ryobi TR45K Manuel d'utilisateur télécharger pdf (Page 15)

Page 14 Page 15

TO SET DEPTH OF CUT

See Figure 10.

n Unplug the trimmer.

n Open the depth adjustment latch as indicated by the ar-

row in figure 10.

n Slide the motor housing section of the trimmer upward

until the tip of the cutter reaches the work surface. The

depth of cut is zero at this point.

n Adjust the position of the trimmer to obtain the desired

depth of cut by moving the motor housing section up or

down, as shown by the up/down arrow in figure 10. The

distance the cutter moves can be read on the depth of

cut scale. Each mark on the scale indicates a 1/16 in. (1.6

mm) change in depth setting. Indicator points are located

on the base.

n Completely close the depth adjustment latch.

WARNING:

Avoid open area of trimmer base. Serious personal injury

will result from contact with a rotating cutter.

NOTE: When adjusting the base, note the groove that serves

as a stop to prevent the motor housing from sliding directly

off and separating from the base.

REMOVING THE BASE

See Figure 11.

n Unplug the trimmer.

n Open the depth adjustment latch.

n Holding the trimmer by the motor housing, slide the base

downward and over. Continue to slide the base downward

to remove it.

NOTE: Replace the base before using the trimmer. Do

not attempt to operate the trimmer without the base in-

stalled.

WARNING:

Always use the laminate sub-base for laminate trimming.

Always use the woodworking sub-base for trim routing

operations. Use of the trimmer without a sub-base or

using the incorrect base can result in serious personal

injury.

OPERATION

Fig. 10

Fig. 11

DEPTH OF

CUT SCALE

STOP

GROOVE

INDICATOR

POINT(S)

DEPTH

ADJUSTMENT

LATCH

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi TR45K Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi TR45K