Ryobi CH120L Manuel d'utilisateur télécharger pdf (Page 6)

 − English

OPERATION

CAUTION:

If at any point during the charging process none of the

LEDs are lit, remove the battery pack from the charger

to avoid damaging the product. DO NOT insert another

battery. Return the charger and battery to your nearest

service center for service or replacement.

CAUTION:

Charge in a well ventilated area. Do not block charger

vents. Keep them clear to allow proper ventilation.

BATTERY PROTECTION FEATURES

Ryobi One+ 12 V lithium-ion batteries are designed with

features that protect the lithium-ion cells and maximize

battery life.

If the tool stops during use, release the trigger to reset and

resume operation. If the tool still does not work, the battery

needs to be recharged.

LED FUNCTIONS OF CHARGER

See Figure 3.

CHARGER LED WILL BE ON TO INDICATE

STATUS OF CHARGER AND BATTERY PACK:

 Red LED on, Green LED off = Power to charger is on.

 Red LED flashing, Green LED off = Battery is being

tested.

 Red LED flashing, Green LED flashing = Battery is

defective.

 Red LED on, Green LED flashing = Battery is charging.

 Red LED off, Green LED on = Battery is fully charged.

CHARGING THE BATTERY PACK

Battery packs for this tool are shipped in a low charge

condition to prevent possible problems. Therefore, you

should charge them until the green LED on the front of the

charger comes on.

CHARGING A COOL BATTERY PACK

If the charger does not charge the battery pack under normal

circumstances, return both the battery pack and charger

to your nearest Authorized Service Center for electrical

check.

 Charge the battery pack only with the recommended

charger.

 Make sure the power supply is normal household voltage,

120 volts, AC only, 60 Hz.

Make sure the latches on each side of the battery pack

snap into place and the battery pack is secured in the

charger before beginning operation.

Connect the charger to the power supply.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

NOTE: After charging is complete, the green LED will

remain on until the battery pack is removed from the

charger or charger is disconnected from the power

supply.

 The battery pack will become slightly warm to the

touch while charging. This is normal and does not

indicate a problem.

 Do not place the charger and battery pack in an area of

extreme heat or cold. They will work best at normal room

temperature.

NOTE: The charger and battery pack should be placed

in a location where the temperature is more than 50°F

but less than 100°F.

When batteries become fully charged, unplug the charger

from the power supply and remove the battery pack.

To remove the battery pack from the charger, depress

the latches on each side of the battery pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack

cool down for approximately 30 minutes before attempting

to recharge.

NOTE: This situation only occurs when continuous use of a

tool causes the batteries to become hot. It does not occur

under normal circumstances. Refer to “CHARGING A COOL

BATTERY PACK” for normal recharging of batteries. If the

charger does not charge your battery pack under normal

circumstances, return both the battery pack and charger

to your nearest Authorized Service Center for electrical

check.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi CH120L Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Ryobi CH120L