Ryobi RMS10 Manuel d'utilisateur télécharger pdf (Page 6)

INSTALLING EXTENSION RAILS

See Figures 3 - 4.

Depress the locking pin and slide the extension rail into

the opening on the end of the stand.

Repeat with the other extension rail on the opposite side

of the stand.

Install two of the adjustment knobs into the ends of the

stand as shown. Tighten securely.

Install the work supports into the ends of the extension

rails.

Install the remaining two adjustment knobs into the exten-

sion rails and tighten securely.

MOUNTING THE MITER SAW BASE TO THE

STAND

See Figure 5.

Place the miter saw base on the stand so that the base is

seated firmly on the stand and the holes in the bottom of

the base are aligned with the threaded shaft of the knobs

in the stand.

Tighten the knobs securely, but do not overtighten.

ASSEMBLY

Fig. 4

Fig. 5

Fig. 3

saw base

stand

knobs

extension

rail

stand

adjustment

knob

work support

extension

rail

adjustment

knob

loCkinG

1 2 3 4 5 6 7 8

Pas de commentaire

Ryobi RMS10 Manuel d'utilisateur Page 6