Ryobi RY09460 Manuel de l'opérateur Page 17

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 16
13 - English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM CAUSE REMEDY
Engine fails to start. No fuel in tank.
Spark plug shorted or fouled.
Spark plug is broken. (cracked
porcelain or electrodes broken)
Ignition lead wire shorted, broken, or
disconnected from spark plug.
Ignition inoperative.
Fill tank.
Replace spark plug.
Replace spark plug.
Replace lead wire or attach to spark
plug.
Contact authorized service center.
Engine hard to start. Water in gasoline or stale fuel.
Engine is under or over choked.
Weak spark at spark plug.
Drain entire system and refill with fresh
fuel.
Adjust choke as necessary.
Contact authorized service center.
Engine lacks power. Air filter clogged. Clean air filter. Refer to Cleaning the
Air Filter Screen earlier in this manual.
Engine starts, runs, and accelerates
but will not idle
Idle speed screw on carburetor needs
adjustment.
Turn idle speed screw clockwise to in-
crease idle speed. See Figure 16.
Engine emits too much smoke Too much oil in crankcase. Drain lubricant and refill with correct
amount of 10W-30 engine lubricant. See
Adding/Checking Engine Lubricant in
the Operation section of this manual.
Engine rope cannot be pulled Oil has entered the combustion
chamber.
This is usually caused by storing the unit
for an extended time with the engine in
an upside-down position. Remove and
clean the spark plug. Drain the oil out
of the spark plug hole, then reinstall the
spark plug.
Vue de la page 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Commentaires sur ces manuels

Pas de commentaire