Ryobi RY80030A Manuel d'utilisateur télécharger pdf (Page 14)

OPERATION

Fig. 14

To stop the engine using the fuel valve:

 Close the fuel valve and wait for the engine to stop.

NOTE: Avoid letting fuel remain in the carburetor for long

periods as this can clog carburetor passages with impuri-

ties resulting in malfunctions.

SELECTING THE RIGHT QUICK-CONNECT

NOZZLE FOR THE JOB

See Figure 14 - 15.

Before starting any cleaning job, determine the best nozzle

for the job. Each of the five nozzles has a different spray

pattern. The nozzle colors and spray patterns are: black

(low pressure), white (medium pressure) 40˚, green (medi-

um pressure) 25˚, yellow (high pressure) 15˚, and red (high

pressure) 0˚.

NOTE: For a gentle rinse, select the white 40˚ or green

25˚ nozzle. Scouring the surface requires a more

direct spray of water. Select the yellow 15˚ or red 0˚

nozzle for tough jobs. Apply detergent using the black

nozzle.



NEVER change nozzles without locking the lock out on

the spray wand.

Using the quick-connect collar, changing nozzles is easy.

Turn off the pressure washer and shut off the water

supply. Pull trigger to release water pressure.

To connect a nozzle to the spray wand:

 Push the nozzle into the quick-connect collar want until

it clicks in place and is secured properly.

To disconnect a nozzle from the spray wand once the

cleaning job is complete:

 Place hand over nozzle then pull back the quick-connect

collar. Place nozzle in the nozzle storage area on the top

of the machine.

USING THE SPRAY WAND TRIGGER

See Figure 16.

For greater control and safety, keep both hands on the spray

wand at all times.

 Pull back and hold the trigger to operate the pressure

washer.

 Release the trigger to stop the flow of water through the

nozzle.

To engage the lock out:

 Push up on the lock out until it clicks into the slot.

To disengage the lock out:

 Push the lock out down and into its original position.

For the most effective cleaning, the spray nozzle should be

between 8 in. and 24 in. from the surface to be cleaned. If

the spray is too close it can damage the cleaning surface.

Fig. 15

slOt

lOCK OUt

nOzzle

qUICK-COnneCt

COllAr

sPrAY WAnD

trIgger

Fig. 16

“ClICK”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY80030A Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Carwash Ryobi RY80030A