Ryobi csb131 Manuel de l'opérateur télécharger pdf (Page 18)

OPERATION

POSITIVE 0° BEVEL STOP

See Figure 19.

Your saw has a positive 0° bevel stop, that has been

factory adjusted to assure 0° angle of the saw blade

when making 90° cuts. However, misalignment can

occur during shipping.

TO CHECK POSITIVE 0° BEVEL STOP

Follow these directions to check the positive 0° bevel

stop.

■ UNPLUG YOUR CIRCULAR SAW.

WARNING:

Failure to unplug the tool could result in accidental

starting causing serious injury.

■ Place the saw in an upside down position on a

workbench.

■ Check the squareness of the saw blade to the base

of the saw using a carpenter’s square.

TO ADJUST POSITIVE 0° BEVEL STOP

Follow these directions to adjust the positive 0° bevel

stop.

■ UNPLUG YOUR CIRCULAR SAW.

WARNING:

Failure to unplug the tool could result in accidental

starting causing serious injury.

■ Loosen bevel adjustment knob.

■ Turn setscrew with hex key and adjust base until it is

square with the saw blade.

■ Tighten bevel adjustment knob securely.

WARNING:

Attempting a bevel cut without having the bevel

adjustment knob securely tightened can result in

serious injury.

LENGTH OF CUT SCALE

See Figure 20.

Your saw is equipped with a length of cut scale on its

base. It is parallel with the saw blade and you can use it

to measure the distance into the material the blade cuts.

NOTE: Six inches is the maximum length of cut that you

can measure. Also, it is accurate only when the depth of

cut is set at full maximum depth.

Fig. 19

Fig. 20

BEVEL

ADJUSTMENT KNOB

CARPENTER’S

SQUARE

SETSCREW

LENGTH OF CUT

SCALE

1 2 ... 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Ryobi csb131 Manuel de l'opérateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi csb131