Ryobi JS451L Manuel de l'opérateur télécharger pdf (Page 14)

14 — English

SCROLL CUTTING

See Figure 12.

Scroll cuts can be made with the jig saw by guiding the

direction of the cut with applied pressure on the handle as

shown.

NOTE: Tighter tolerance scroll cutting may require the use

of a scroll cutting blade (not included).

WARNING:

Excessive side pressure to the blade could result in

broken blades or damage to the material being cut.

PLUNGE CUTTING

See Figure 13.

NOTE: Use only a 7-teeth-per-inch blade for this type of

cut.

WARNING:

To avoid loss of control, broken blades, or damage to

the material being cut, always use extreme caution when

making plunge cuts. We do not recommend plunge cut-

ting on materials other than wood.

 Mark the line of cut clearly on the workpiece.

 Set the orbit adjustment to “0”.

 Set the cutting angle at 0°.

 Tilt the saw forward so that it rests on the front edge

of the base and blade will not come in contact with the

workpiece when the saw is turned on.

 Make sure the blade is inside the area to be cut.

 Using high speed, start the saw and slowly lower the

blade into the workpiece until the blade cuts through the

wood.

Continue lowering the blade into the workpiece until the

base rests flat on the work surface, then move the saw

forward to complete the opening.

OPERATION

Fig. 12

Fig. 13

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ryobi JS451L Manuel de l'opérateur Page 14