Ryobi P4360 Manuel de l'opérateur télécharger pdf (Page 15)

Page 15 — English

WARNING:

When servicing, use only identical replacement

parts. Use of any other parts could create a

hazard or cause product damage.

WARNING:

Always wear eye protection with side shields

marked to comply with ANSI Z87.1, along with

head protection. Failure to do so could result in

objects being thrown into your eyes and other

possible serious injuries.

WARNING:

Before inspecting, cleaning, or servicing the

unit, stop the motor, wait for all moving parts

to stop, and remove the battery pack. Failure

to follow these instructions can result in serious

personal injury or property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts.

Most plastics are susceptible to damage from

various types of commercial solvents and may be

damaged by their use. Use clean cloths to remove

dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline,

petroleum-based products, penetrating oils, etc.,

come in contact with plastic parts. Chemicals can

damage, weaken, or destroy plastic, which could

result in serious personal injury.

All pole saw service, other than the items listed in

these maintenance instructions, should be per-

formed by competent pole saw service personnel.

(For example, if improper tool is used to hold the

flywheel in order to remove the clutch, structural

damage to the flywheel could occur and subse-

quently could cause the flywheel to burst).

CHAIN TENSION

See Figures 11 - 12.

WARNING:

To avoid possible serious injury, never touch or

adjust the chain while the motor is running. The

saw chain is very sharp; always wear protec-

tive gloves when performing maintenance to

the chain.

 Stop the motor and remove the battery pack

before setting the chain tension. Make sure

the chain cover screw is loose to finger tight,

turn the chain tensioning screw clockwise to

tension the chain. Refer to Replacing the Bar

and Chain for additional information.

NOTE: A cold chain is correctly tensioned when

there is no slack on the underside of the guide

bar, the chain is snug, but it can be turned by

hand without binding.

 Chain must be re-tensioned whenever the flats on

the drive links hang out of the bar groove as

shown in fig. 11.

 During normal operation, the temperature of the

chain will increase. The drive links of a correctly

tensioned warm chain will hang approximately

.050 in. out of the bar groove, as shown in

fig. 12.

FLATS

APPROX .050 in.

Fig. 12

Fig. 11

MAINTENANCE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Ryobi P4360 Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi P4360