Ryobi SC155VS Manuel de l'opérateur télécharger pdf (Page 21)

21

TROUBLESHOOTING

Motor will not run.

Blades breaking.

Vibration

(there is always some vibration

when the saw is running).

Blade runout (blade not properly

aligned with arm motion).

PROBLEM CAUSE SOLUTION

1. Problem with ON-OFF switch,

power cord, or outlet.

2. Motor defective.

1. Too much tension.

2. Feeding too quickly.

3. Wrong blade.

4. Blade twisting in wood.

1. Improper mounting of saw.

2. Mounting surface.

3. Loose table or table resting

against motor.

4. Loose motor mounting.

1. Blade holders out of line.

1. Have worn parts replaced before using

scroll saw again. Have the proper outlet

installed by a qualified electrician.

2. Do not attempt any repair. Have repaired

by a qualified service

technician.

1. Adjust tension.

2. Reduce feed rate.

3. Narrow blades for cutting thin wood or

tight corners and turns, wide blades for

thicker wood or wide turns.

4. Reduce side pressure on blade; check

blade tension.

1. Check mounting.

2. Check mounting in manual.

3. Tighten table lock knob.

4. Tighten mounting screws.

1. Realign blade.

1 2 ... 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire