Ryobi RY09800 Manuel d'utilisateur télécharger pdf (Page 10)

9 — English

OPERATION

STARTING AND STOPPING

See Figures 7 - 9.

Blower should be on a flat, bare surface for starting.

 Slowly press the primer bulb 10 times.

NOTE: After the 10th press, fuel should be visible in the

primer bulb. If it is not, continue to press the primer until

you see fuel in the bulb.

 Set the choke lever to the FULL CHOKE position.

 Lock cruise control.

 Pull starter grip sharply until engine attempts to run. Do

not pull the starter grip more than four (4) times.

 Set the choke lever to the HALF CHOKE position.

 Pull the starter grip and rope until the engine runs. Do

not pull the starter grip more than six (6) times.

NOTE: If the engine does not start, return to the FULL

CHOKE position and repeat the steps that follow.

 Allow the engine to run for 10 seconds, then set the choke

lever to the RUN position.

TO STOP THE ENGINE:

 To stop the engine, depress the STOP switch to the stop

position “ O ”.

HOT RESTART OF THE ENGINE:

 Set the choke lever to the RUN position.

 Lock cruise control.

 Pull the starter grip until the engine runs.

IF ASSISTANCE IS REQUIRED STARTING THIS

PRODUCT:

Do not return this product to the retail store where it was

purchased. Please call our Customer Service Department

for any issues you may have.

For Help Call: 1-800-860-4050.

WARNING:

Keep away from the muffler and all hot surfaces of the

blower. Failure to do so could result in possible serious

personal injury.

OPERATING THE BLOWER

See Figure 10.

 Slip arm through harness strap and onto shoulder, then

repeat for the other shoulder. Adjust the straps to a

comfortable position. Refer to Adjusting Harness Straps

earlier in this manual. Remove unit for starting.

 Start the blower. Refer to Starting and Stopping earlier

in this manual.

 Put on the blower again. The unit should be operated on

the operator’s right side as shown.

 To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the center

of a pile.

 Operate power equipment at reasonable hours only —

not early in the morning or late at night when people

might be disturbed. Comply with the times listed in local

ordinances.

 To reduce sound levels, limit the number of pieces of

equipment used at any one time.

 Operate blower at the lowest possible throttle speed to

do the job.

 Check your equipment before operation, especially the

muffler, air intakes, and air filters.

 Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water

is available.

 Conserve water by using power blowers instead of hoses

for many lawn and garden applications, including areas

such as gutters, screens, patios, grills, porches, and

gardens.

 Watch out for children, pets, open windows, or freshly

washed cars, and blow debris safely away.

 Use the nozzle for larger volume, so the air stream can

work close to the ground.

 After using blowers or other equipment, CLEAN UP!

Dispose of debris properly.

WARNING:

Do not place blower on top of or near loose debris. Debris

may be sucked into blower intake vent resulting in serious

personal injury and possible damage to the unit.

CRUISE CONTROL

See Figure 11.

The cruise control can be used to operate the blower without

holding the throttle trigger.

To engage the cruise control:

 Pull cruise control lever back toward user, and stop at

the desired throttle setting.

 To release the cruise control, push cruise control lever all

the way toward the front of unit.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 44 45

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY09800 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi RY09800