Ryobi RY39506 Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 42
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
13 - English
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY
Engine will not start. No spark.
No fuel.
Engine is flooded.
Starter rope pulls harder
now than when new.
Clean or replace spark plug. Reset spark plug gap. Refer to Spark
Plug Replacement earlier in this manual.
Push primer bulb until bulb is full of fuel. If bulb does not fill, primary
fuel delivery system is blocked. Contact a servicing dealer. If primer
bulb fills, engine may be flooded, proceed to next item.
Pull starter rope three times with choke lever at “RUN”. If engine
does not start, move choke lever to “START” and repeat normal
starting procedure. If engine still fails to start, repeat procedure
with a new spark plug.
Contact a servicing dealer.
Engine starts but will
not accelerate.
Engine requires approxi-
mately three minutes to
warm up.
Allow engine to completely warm up. If engine does not accelerate
after three minutes, contact a servicing dealer.
Engine starts but will
only run at high speed
at half choke.
Carburetor requires
adjustment.
Contact a servicing dealer.
Engine does not reach
full speed and emits
excessive smoke.
Check lubricant fuel mix-
ture.
Air filter screen is dirty.
Spark arrestor screen is
dirty.
Use fresh fuel and the correct 2-cycle lubricant mix.
Clean air filter screen. Refer to Cleaning The Air Filter Screen
earlier in this manual.
Contact a servicing dealer.
Engine starts, runs,
and accelerates but
will not idle.
Idle speed screw on
carburetor needs adjust-
ment
Turn idle speed screw clockwise to increase idle speed. See fig-
ure 11. The blades should not move at idle.
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Commentaires sur ces manuels

Pas de commentaire