Ryobi 150r Manuel d'utilisateur télécharger pdf (Page 5)

BOOM COUPLrRJl

Your unit may or may not be completely

assembled. If it is not assembled, use

the following instructions,

Loosen the 2 cover wing screws

and swivel cover. Install the

carriage bolt through the housing

and secure the wheel bracket

assembly with the adjustment knob

and flat washer. Make sure the

carriage bolt is properly seated

mrough the housing (Fig. 1).

f

Fig. 1

2. Pull the flex shaft out of the boom

about 51 "am {2 inL Insert the shaft

into the square hole in the housing

(Fig. 2),

/

/

Fig. 2

3. Back out the anti-rotation screw

ana push the boom assembly into

the casting, Rotate until the hole in

the boom is aligned with the hole in

the casting, Install the anti-rotation

screw and tighten the clamp screw

(Fig. 3).

Fig, 3

1. Loosen the wing screws of the

Split Boom ®coupler. This will allow

the lower (attachment} boom to be

inserted into the coupler (Fig. 4).

2,

2.

Fig. 4

Remove the protective coverfrom

the {owerboom and oush it intothe

coupler(Fig 5).

3,

Before locking the release button

into the coupler, rotate the boom 90

oegrees; then rotate the lower

boom back 90 degrees. This will

ensure the drive shafts in both the

upper and lower booms are

engaged,

3,

4.

Coupler

Wing Screw

Fig. 5

Locate and lock the release button

into the hole in the coupler (Fig. 5).

Check the sight hole to make sure

both ends of the boom are together

(Fig. 6). Tighten me wing screws

before using.

5. To remove the attachment, loosen

the wing screws, push the release

I_uttonand pull the lower boom

straight out of the coupler (Fig, 6),

Wing

Coupler

Fig. 6

The edger is designed to cut deep

edges along paths, driveways,

rockeries etc. It may be necessary

to first dig a smell trench along the

edge so the blade can rotate at

speed. By regularly edging the

path. the trench will be maintained

and the blade will cut effectively.

Do not force the unit into deep

overgrown edges because this

may cause damage to the blade or

drive mechanism.

The illustration below shows the

typical operating position. Edge

along paths, driveways, gardens

(Fig. 7).

Fig. 7

4. To adjust the blade cutting depth.

loosen the adjustment knob above

the wheel. Slide the bracket into the

desired position and retighten the

knob (Fig. 8).

Fig. 8

5¸

1 2 3 4 5 6 7 8 9 10 ... 15 16

Commentaires sur ces manuels

Pas de commentaire