Ryobi 155r Manuel de l'opérateur télécharger pdf (Page 15)

TROUBLESHOOTING

CAUSE ACTION

Cutting attachment bound with grass Stop the unit and clean cutting attachment

Cutting attachment out of line Refill with new line

Inner reel bound up Replace the inner reel

Cutting attachment dirty Clean inner reel and outer spool

Line welded Disassemble, remove the welded section

and rewind the line

Line twisted when refilled Disassemble and rewind the line

Not enough line is exposed Push the Bump Knob and pull out line until

4 inches (102 mm.) of line is outside of the

cutting attachment

CAUSE ACTION

Battery is not charged Charge battery. See Charging the Unit, page 8.

Overload protection switch has popped Reset overload protection switch

MOTOR OPERATES SLOWLY OR WILL NOT OPERATE

BATTERY WILL NOT CHARGE

CAUSE ACTION

No power to charger or battery Check charger and charging station. See Charging

the Unit, page 8.

Battery has failed Replace battery. See Battery Pack Replacement,

page 13.

CUTTING ATTACHMENT WILL NOT ADVANCE LINE

SPECIFICATIONS

Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Volt DC, 15 Amps

Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sealed Lead-Acid, 12 Volt

Motor Wire Housing Tube . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Aluminum Tube

Unit Weight (With battery, cutting attachment shield and D-handle) . . . . . . . . . . . . . . . . . . . . . . . . 10.2 lbs. (4.63 kg.)

Cutting Mechanism . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Bump Head

Line Spool Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 in (76.2 mm)

Trimming Line Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.080 in (2.03 mm.)

Cutting Path Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 in. (254 mm)

BATTERY AND MOTOR