Ryobi RJ160V Manuel de l'opérateur télécharger pdf (Page 9)

Page 9

■ Align the hole in the shank of the blade and blade clamp

with the pin in the saw bar, then seat both on the pin in the

saw bar.

■ Tighten blade clamp screw securely. Do not overtighten

screw or use an aid with hex key.

■ Remove hex key and store it in the hex key holder.

Note: There may be times when the blade clamp sticks to the

saw bar and will not loosen enough to allow blades to be

installed or removed. If this happens, loosen the blade clamp

screw with the hex key, then tap lightly on the end of the hex

key with a mallet.

See Figure 4.

BASE ASSEMBLY

See Figure 5.

The base assembly of your reciprocating saw pivots up and

down in both directions. The base is adjustable, allowing the

use of the blade teeth at different positions on the blade.

TO CHANGE POSITIONS OF THE BASE ASSEMBLY:

See Figure 6.

■ UNPLUG YOUR SAW.

WARNING:

Failure to unplug your saw could result in accidental

starting causing serious injury.

■ Loosen the button head screws in the gear frame with the

3 mm hex key mentioned above.

■ Reposition base assembly.

■ Retighten button head screws securely. Do not overtighten

screws or use an aid with hex key.

■ Remove hex key and store it in hex key holder.

BLADE

CLAMP

OPERATION

HEX KEY

Fig. 5

MALLET

BASE

ASSEMBLY

HEX KEY

BLADE

CLAMP SCREW

Fig. 4

BASE

ASSEMBLY

PIVOT

BUTTON

HEAD SCREWS

Fig. 6

SAW BAR

Cutting into electrical wiring in walls can cause blade, blade

clamp, and saw bar assembly to become electrically live.

Do not touch metal parts when cutting into a wall; grasp

only the insulated gripping surface provided on the tool.

Make sure hidden electrical wiring, water pipes, and

mechanical hazards are not in the blade path when cut-

ting into a wall.

WARNING:

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire

Ryobi RJ160V Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi RJ160V