Ryobi RY52001A Manuel de l'opérateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 26
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
14 15
OPERATION
ST
OP
HALF
CHOKE (B)
FULL
CHOKE (A)
RUN (C)
CHOKE LEVER
Fig. 16
POSITION FOR STARTING
See Figure 13.
Lay the pruner on the ground and ensure that no objects or
obstructions are in the immediate vicinity. Make sure nothing
can come in contact with the bar and chain.
Fig. 15
STARTER GRIP
THROTTLE TRIGGER
ENGINE
SWITCH
STARTING
INSTRUCTION
LABEL
PRIMER BULB
Fig. 14
THROTTLE
TRIGGER
ENGINE SWITCH
Fig. 13
STARTING AND STOPPING
See Figures 14 - 16.
Unit should be on a flat, bare surface for starting.
n Slowly push the primer bulb 5 times.
n Set the choke lever to the FULL CHOKE position (A).
n Squeeze the throttle trigger fully. Do not release until all
of the remaining steps are completed.
n Pull the starter handle sharply 3 times until the engine
attempts to run. Do not pull the starter handle more than
8 times.
n
Set the choke lever to the HALF CHOKE position (B).
n Pull the starter handle until the engine runs. Do not pull
the starter handle more than 6 times.
n Allow the engine to run for 15 seconds, then set the choke
lever to the RUN position (C).
TO STOP THE ENGINE:
See Figure 14.
Press and release
on the engine switch to stop the
engine.
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Commentaires sur ces manuels

Pas de commentaire