Page 11
MAINTENANCE
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
leum-based products, penetrating oils, etc. come in
contact with plastic parts. They contain chemicals that
can damage, weaken, or destroy plastic.
Electric tools used on fiberglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure because the fiberglass
chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. Consequently, we do not
recommend using this tool for extended work on these
Problem Possible Cause Solution
TROUBLESHOOTING
Wax does not go on evenly. Too much wax on the bonnet. Remove a portion of the wax and retry.
Polishing seems difficult. Bonnet may be worn. Replace bonnet.
Polisher does not turn on. Bad connection to receptacle. Check to make sure plug is properly
seated in outlet. If using an extension
cord, check connection and wire gauge.
Problem with motor. Call your Ryobi authorized service center.
Bonnet surface is creased or Drawstring is loose. Untie drawstring and retighten.
wrinkled, resulting in uneven
application/buffing.
Pad spins slower than normal or Motor needs to be serviced or Call your Ryobi authorized service center.
not at all. replaced.
types of materials. However, if you do work with any of
these materials, it is extremely important to clean the tool
using compressed air.
APPLICATION AND BUFFING BONNETS
Both the application and buffing bonnets are reusable. For
maximum life and performance, hand wash after use and
allow them to air dry. If needed, the bonnets can be
machine washed in cold water with a small amount of
detergent, then machine dried using low heat.
FOAM PAD
It is important that the pad retains its original shape and
dimensions. Allow it to dry completely after each use. Make
sure to remove the bonnets, wash them and store separately.
Polisher should be stored with the pad facing up in order to
extend pad life and retain its shape. Be careful not to use
too much polish at one time. If the pad becomes saturated,
it will not last as long.
MOTOR AND INTERNAL COMPONENTS
The motor and internal components are designed to be
maintenance free. The exterior surface can be cleaned with
a mild soap and damp sponge.
If you suspect a problem with the motor or other internal
components, do not attempt to remove the motor housing
or otherwise expose the internal components. Contact
Ryobi Customer Service at 1-800-525-2579 for the
authorized service center nearest you.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the tool under
normal operating conditions. Therefore, no further
lubrication is required.
WARNING:
The buffer/polisher should never be connected to a
power supply when you are assembling parts, making
adjustments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool will
prevent accidental starting that could cause serious
injury.
WARNING:
When servicing use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
(12 pages)
(18 pages)
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels