Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 77)

Page 68 Power Equipment Usage Manual (Rev. 5/10)

13.3.9. Miter Joints

a. Layout groove positions as described in Section

15.3.5 Positioning Grooves.

b. Set depth stop turret to desired biscuit size.

c. Set the tilt fence to desired angle (see Section

15.3.4 Angle Adjustment).

d. Set fence height adjustment to desired height

(see Section 15.3.3 Height Adjustment).

e. Clamp workpiece securely.

f. Position tool to workpiece utilizing either guide

notch (A) or (B) Figure 19, to align tool with a

groove centerline. Apply pressure to auxiliary

handle (C) Figure 19, to hold tool firmly in place.

g. Hold tool firmly as shown in Figure 20, and squeeze

trigger switch to start tool.

h. At a slow, steady pace, push tool forward in base as far

as depth stop allows.

i. Release trigger switch to stop tool and remove tool

from work.

j. Repeat steps e. through h. until all the grooves for this

joint are completed.

NOTE: Assemble all joints and verify alignments before

applying glue (see Figure 21).

Fig.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 77