Ryobi TS1302 Manuel de l'opérateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 22
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Page 13
45
30
15
3
0
45
3
1
.6
2
22.5
3
1
.
6
2
2
2
.5
0
45
30
15
30
45
3
1.6
2
22.5
3
1
.6
2
2
2
.5
45
30
15
30
4
5
3
1
.6
2
2
2
.
5
31.62
2
2
.
5
ASSEMBLY
Fig. 13
Fig. 14
Fig. 15
Fig. 16
CLAMP
BRACKET SCREW
MITER
SAW BASE
SAW VIEWED FROM BOTTOM
STOP BLOCK
SMALL
WING SCREW
MITER
SAW BASE
TABLE
EXTENSION
TABLE
EXTENSION
CLAMP
BRACKET
CLAMP
BRACKET
ASSEMBLED
STOP BLOCK
BRACKET
SUPPORT
MITER
SAW BASE
TABLE EXTENSIONS
See Figures 13, 14, and 15.
If you plan to use the stop block, slide the stop block on the
back arm of the desired table extension first.
See Figure 13.
To install table extensions, insert the ends of extensions into
the holes in the sides of the base.
See Figures 13 and 14.
Adjust the extensions to the desired length.
Secure them in place by positioning a clamp bracket under
each table extension beneath the miter table. Orient each
clamp bracket as shown in figure 15.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom of
miter table, securing clamp bracket against table extension.
STOP BLOCK
See Figures 13 and 16.
The stop block is included with the Table extensions and is
useful as a stop for making repetitive cuts to the same
length. It can be installed on either side of the saw base:
Slide the stop block on the back arm of either table
extension, then insert the table extensions into the saw
base.
See Figure 13.
Use the small wing screw to secure the stop block to the
table extensions.
See Figure 13.
Loosen the small wing screw and adjust the stop block
the desired distance from the blade for the cut to be
made. For accurate placement of the stop block, mea-
sure the distance from the teeth set on the blade to the
stop block.
Tighten wing screw securely.
Make a test cut in scrap material and measure the
length of the workpiece.
Make any necessary adjustments.
WARNING:
Always make sure your miter saw is securely mounted to
a workbench or an appropriate workstand. Failure to do
so could result in an accident resulting in possible serious
personal injury.
TABLE
EXTENSION
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Commentaires sur ces manuels

Pas de commentaire