Ryobi TS1352 Manuel d'utilisateur télécharger pdf (Page 26)

Page 26

CUTTING WARPED MATERIAL

See Figures 36 and 37.

When cutting warped material, always make sure it is

positioned on the miter table with the convex side against the

fence as shown in figure 36.

If the warped material is positioned the wrong way as shown

in figure 37, it will pinch the blade near the completion of the

cut.

WARNING:

To avoid a kickback and to avoid serious personal

injury, never position the concave edge of bowed or

warped material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 38.

When cutting wide workpieces, such as 51 mm x 152 mm (52

in. x 6 in.), boards should be clamped with a C-clamp as

shown in figure 38.

OPERATION

Bevel

Angle Type of Cut

Setting

Left side, inside corner

1. Top edge of molding against fence

2. Miter table set right 31.62

3. Save left end of cut

Right side, inside corner

1. Bottom edge of molding against fence

2. Miter table set left 31.62

3. Save left end of cut

Left side, outside corner

1. Bottom edge of molding against fence

2. Miter table set left 31.62

3. Save right end of cut

Right side, outside corner

1. Top edge of molding against fence

2. Miter table set right 31.62

3. Save right end of cut

33.85

Fig. 36

RIGHT

22.5

31.6

22.5

31.6

4 5

22.5

31.6

4 5

WRONG

Fig. 37

4 55

33 0

22.522.

22.

Fig. 38

WIDE

BOARD

1 2 ... 21 22 23 24 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1352 Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi TS1352