Ryobi CS1800 Manuel de l'opérateur Page 20
- Page / 32
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
20
ASSEMBLY
SQUARING THE BLADE TO THE FENCE
See Figures 21 - 24.
Unplug the saw.
Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
Lift the miter lock lever.
Rotate the miter table until the pointer aligns with zero
on the miter scale.
Push the miter lock lever down to lock the miter table.
Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
The edge of the square and the saw blade should be
parallel as shown in figure 20.
If the front or back edge of the saw blade angles away
from the square as shown in figures 23 and 24, adjust-
ments are needed.
Using the blade wrench, loosen the socket head screws
that secure the miter fence to the miter table. See figure
21.
Rotate the miter fence left or right until the saw blade is
parallel with the square.
Retighten the screws securely and recheck the blade-to-
fence alignment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero.
Miter
Lock
Lever
Fig. 22
Miter
tabLe
view of bLade square with fence
square
view of bLade not square with fence, adJustMents
are required
Fig. 23
Fig. 21
Miter
fence
socket head
screw(s)
socket head
screw(s)
Fig. 24
view of bLade not square with fence, adJustMents
are required
Miter
fence
bLade
Miter
tabLe
square
Miter
fence
bLade
Miter
tabLe
square
Miter
fence
bLade
- OPERATOR’S MANUAL 1
- TABLE OF CONTENTS 2
- INTRODUCTION 2
- WARRANTY 2
- GENERAL SAFETY RULES 3
- SPECIFIC SAFETY RULES 4
- WARNING: 6
- CAUTION: 6
- ELECTRICAL 7
- GLOSSARY OF TERMS 8
- FEATURES 10
- TOOLS NEEDED 11
- LOOSE PARTS LIST 12
- ASSEMBLY 13
- OPERATION 22
- ADJUSTMENTS 29
- MAINTENANCE 31
Produits connexes et manuels pour Scies à chaîne Ryobi CS1800
(26 pages)
(60 pages)
(56 pages)
(1 pages)HP TOUCHSMART 9100 manuels
Manuels d'utilisation et guides de l'utilisateur pour PC/postes de travail HP TOUCHSMART 9100.
Nous fournissons des manuels en pdf 1 HP TOUCHSMART 9100 à télécharger gratuitement par type de document : Guide de l'utilisateur
Commentaires sur ces manuels