Ryobi RY10520 Manuel de l'opérateur télécharger pdf (Page 16)

Page 16 — English

STOPPING THE ENGINE

See Figures 12 - 13.

Release the throttle trigger and let the engine return

to idle. To stop the engine, move the ignition switch

to the STOP

( O ) position. Do not put the chain

saw on the ground when the chain is still moving.

For additional safety, set the chain brake when the

saw is not in use.

In the event that the ignition switch will not stop the

saw, pull the choke lever out to the fully extended

position (FULL CHOKE

) and engage chain brake

to stop the engine. If the ignition switch will not

stop the saw when set to the STOP position, have

the ignition switch repaired before using the chain

saw again to prevent unsafe conditions or serious

injury.

NOTE:

When you are finished using the saw,

always relieve tank pressure by loosening, then

retightening, the chain oil and fuel caps. Allow the

engine to cool before storing.

ADJUSTING IDLE SPEED

See Figure 14.

If the engine starts, runs, and accelerates,

but will not idle, turn the idle speed screw “T”

clockwise to increase idle speed.

If the chain turns at idle, turn the idle speed

screw “T” counterclockwise to reduce the

idle RPM and stop the chain movement. If the

saw chain still moves at idle speed, contact an

authorized service center for adjustment and

discontinue use until the repair is made.

BRAKE

POSITION

Fig. 13

Fig. 14

IGNITION

SWITCH IN THE

STOP POSITION

IDLE SPEED

SCREW “T”

Fig. 12

OPERATION

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY10520 Manuel de l'opérateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Ryobi RY10520