Ryobi DP121L Manuel de l'opérateur télécharger pdf (Page 14)

ASSEMBLY

INSTALLING TABLE AND TABLE SUPPORT

See Figures 6 - 8.

Loosen the set screw in the column collar. Remove the

column collar and gear rack from the column and set

aside.

Locate the worm gear and feed the D-shaft through the

hole in the table support.

Feed the gear rack through the slot in the table support so

that the teeth are facing out and the longer smooth end

faces up. The worm gear should engage the gear rack.

 Using both hands, slide the entire table support and gear

rack onto the column until the bottom of the gear rack is

positioned in the base collar and against the column.

Slide the column collar, bevel-side down, over the column

until the beveled side engages the beveled end of the

gear rack. Tighten the set screw in the collar using the

hex key. Do not overtighten.

NOTE: You should be able to move the table support

from side to side.

Install table adjustment handle over the end of the

D-shaft so that the flat side of the shaft aligns with the

set screw. Using the hex key, tighten the set screw on

the table adjustment handle.

Locate the table lock handle. Insert it into the threaded

hole at the rear of the table support and tighten by

hand.

Remove protective covering from the table and discard.

Place the table in the table support and tighten the table

lock handle by hand.

NOTE: If the table won’t fit into the table support

easily, pry open the table support with a flat blade screw-

driver.

Fig. 7

THREADED

HOLE

TABLE

LOCK

HANDLE

Fig. 8

WORM

GEAR

Fig. 6

D-SHAFT

SLOT

GEAR

RACK

TABLE

SUPPORT

COLUMN

COLLAR

SET

SCREW

BASE

COLLAR

SET

SCREW

TABLE

ADJUSTMENT

HANDLE

TABLE

SUPPORT

TABLE

SUPPORT

TABLE

LOCK

HANDLE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi DP121L Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Ryobi DP121L