Ryobi RY44140 Manuel d'utilisateur télécharger pdf (Page 13)

Page 11 – English

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Wear head protection when

operating this equipment above shoulder level. Failure

to do so could result in objects being thrown into your

eyes and other possible serious injuries.

WARNING:

Before inspecting, cleaning, or servicing the machine,

disconnect the plug from power source and wait for all

moving parts to stop. Failure to follow these instruc-

tions can result in serious personal injury or property

damage.

GENERAL MAINTENANCE

Before each use, inspect the entire product for damaged,

missing, or loose parts such as screws, nuts, bolts, caps, etc.

Tighten securely all fasteners and caps and do not operate

this product until all missing or damaged parts are replaced.

Please call 1-800-860-4050 or contact an authorized service

center for assistance.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken, or

destroy plastic which may result in serious personal

injury.

Only the parts shown on the parts list are intended to be

repaired or replaced by the customer. All other parts should

be replaced at an Authorized Service Center.

WARNING:

Blades are sharp. When handling the blade assembly,

wear non-slip, heavy-duty protective gloves. Do not place

your hand or fingers between blades or in any position

where they could get pinched or cut. NEVER touch blades

or service unit with the power supply connected.

LUBRICATING THE BLADE

See Figure 9.

For easier operation and longer blade life, lubricate the hedge

trimmer blade before and after each use.

 Stop the motor and disconnect plug from power supply.

Lay the hedge trimmer on a flat surface. Apply light weight

machine oil along the edge of the top blade.

If you will be using the hedge trimmer for an extended period,

it is advisable to oil the blade during use.

NOTE: Do not oil while the hedge trimmer is running.

 Stop the motor and disconnect plug from power supply.

Lubricate the hedge trimmer as described above.

Reconnect plug to the power source and resume use.

SHARPENING THE BLADE

See Figure 10.

 Allow the blades of the hedge trimmer to come to a stop

in the position shown. This will allow clearance for the

file between the cutter teeth and the guard teeth.

 Disconnect the plug from the power source.

 Clamp the blade assembly in a vise and file the exposed

cutting surface of each blade tooth with an 8 in. smooth

round file, 1/4 in. or 7/32 in. in diameter. Be sure to retain

the original angle of the tooth when filing.

 Remove the hedge trimmer from the vise, reconnect plug

to the power source, and restart the hedge trimmer. Al-

low the blades of the hedge trimmer to come to a stop

so that the unsharpened edges on the other side of the

cutter blade teeth are exposed.

 Disconnect the plug from the power source and repeat

the sharpening procedure as described above.

CLEANING THE HEDGE TRIMMER

 Stop the motor and disconnect plug from power supply.

Clean dirt and debris from the body of the hedge trimmer,

using a damp cloth with a mild detergent.

NOTE: Do not use any strong detergents on the plastic

housing or the handle. They can be damaged by certain

aromatic oils such as pine and lemon, and by solvents

such as kerosene.

TRANSPORTING AND STORING

See Figure 11.

 Always place the blade cover on the blade before storing

or transporting the hedge trimmer. Use caution to avoid

the sharp teeth of the blade.

 Clean the hedge trimmer thoroughly before storing. Store

the hedge trimmer indoors, in a dry place that is inacces-

sible to children. Keep away from corrosive agents such

as garden chemicals and de-icing salts.

MAINTENANCE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY44140 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Taille-haie électrique Ryobi RY44140