Ryobi SP450 Manuel d'utilisation et d'entretien télécharger pdf (Page 7)

7 – English

FEATURES

PRODUCT SPECIFICATIONS

Disc/Polishing Bonnet Size ..............................................................................................................................................6 in.

Spindle Size ..........................................................................................................................................................1/2-20 UNF

No Load Speed .......................................................................................................................1,400 and 1,650 r/min. (RPM)

Input ....................................................................................................................................120 V, AC only, 60 Hz, 4.5 Amps

ASSEMBLY

UNPACKING

This product requires assembly.

 Carefully remove the tool and any accessories from the

box. All items listed in the Includes section must be

included at the time of purchase.

WARNING:

Items in this Assembly section are not assembled to

the product by the manufacturer and require customer

installation. Use of a product that may have been

improperly assembled could result in serious personal

injury.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance. In Mexico, please call

01-800-843-1111.

WARNING:

If any parts are damaged or missing do not operate this

product until the parts are replaced. Use of this product

with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create

accessories or attachments not recommended for use

with this product. Any such alteration or modification is

misuse and could result in a hazardous condition leading

to possible serious personal injury.

INSTALLING/REMOVING RUBBER DISC

See Figure 1, page 11.

Unplug the sander/polisher.

Position the tool as shown and align the spindle lock hole

with the two half-circle notches in motor housing. Lock

spindle by inserting the pin provided through spindle lock

hole and trapping it in the half circle notches. This will

prevent the spindle from rotating.

Thread rubber disc, flat face up, onto spindle in a clock-

wise direction. Turn until rubber disc shoulders on the

spindle.

Start spanner nut onto threaded spindle in a clockwise

direction.

Securely tighten spanner nut with the spanner wrench

provided.

Remove pin securing spindle.

To remove:

Unplug the sander/polisher.

Position the tool as shown and insert pin to secure

spindle.

Loosen spanner nut with the spanner wrench provided

by turning counterclockwise.

Remove spanner nut.

Turn rubber disc counterclockwise to remove.

Remove pin securing spindle.

INSTALLING SIDE HANDLE

See Figure 2, page 11.

 Unplug the sander/polisher.

 Insert the side handle into the desired operating position.

Securely tighten by turning the handle clockwise.

NOTE: The side handle must always be used to prevent loss

of control and prevent injury.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi SP450 Manuel d'utilisation et d'entretien Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Ponceuses électriques Ryobi SP450