Ryobi 7-1/4 in Compound Miter Saw TS1141 Manuel d'utilisateur télécharger pdf (Page 29)

ADJUSTMENTS

WARNING:

Before performing any adjustment, make sure the tool is

unplugged from the power supply. Failure to heed this

warning could result in serious personal injury.

The compound miter saw has been adjusted at the

factory for making very accurate cuts. However, some of

the components might have been jarred out of alignment

during shipping. Also, over a period of time, readjustment

will probably become necessary due to wear. After unpacking

the saw, check the following adjustments before you begin

using the saw. Make any readjustments that are necessary

and periodically check the parts alignment to make sure that

the saw is cutting accurately.

CAUTION:

Do not start the compound miter saw without checking

for interference between the blade and the throat plate.

Damage could result to the blade if it strikes the throat

plate during operation of the saw.

PIVOT ADJUSTMENTS

NOTE: These adjustments were made at the factory and

normally do not require readjustment.

TRAVEL PIVOT ADJUSTMENT

 The saw arm should rise completely to the up position

by itself.

 If the saw arm does not raise by itself or if there is play

in the pivot joints, have saw repaired by at your nearest

authorized service center.

BEVEL PIVOT ADJUSTMENT

 The compound miter saw should bevel easily by loosening

the bevel lock knob and tilting the saw arm to the left.

 If movement is tight or if there is play in the pivot, have saw

repaired by at your nearest authorized service center.

Fig. 39

positive stop

adJustMent

screw for

45° angLes

positive stop

adJustMent

screw for

0° angLes

POSITIVE STOP ADJUSTMENTS

See Figure 39.

NOTE: These adjustments were made at the factory and

normally do not require readjustment.

To adjust:

 Unplug the saw.

 Loosen the bevel lock knob by turning the knob

counterclockwise.

 Square the blade to the miter table as described in the

Assembly section of this manual.

 If the blade is out of square, adjust by tightening or

loosening the positive stop adjustment screw.

 Retighten bevel lock knob. Recheck blade-to-table

alignment.

NOTE: The above procedure can be used to check blade

squareness of the saw blade to the miter table at both 0°

and 45° angles.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

beveL Lock

knob

1 2 ... 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi 7-1/4 in Compound Miter Saw TS1141 Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi 7-1/4 in Compound Miter Saw TS1141