Ryobi BT300 Manuel d'utilisateur télécharger pdf (Page 8)

ASSEMBLY

Fig. 10

Fig. 11

REAR

EXTENSION RAIL

SQUARE HEAD BOLT

(1/4-20X1/2 IN.)

TABLE

BRACKET

WASHER

(1/4 IN.)

HEX NUT

(1/4 IN.)

REAR

EXTENSION

TABLE

AUXILIARY

EXTENSION

TABLE

OPTIONAL BRACE

OPTIONAL

BRACE

SLIDING MITER TABLE

TABLE SAW SHOWN WITH

THE AUXILIARY EXTENSION TABLE AND

THE REAR EXTENSION TABLE

This kit also includes brackets and connecting hardware for

making an extension table behind the blade to provide support

and control when ripping large panels. The size of this table

should be made according to application requirements and

individual preferences.

TO ATTACH TABLE BRACKETS

See Figure 10.

 Insert the (four) square head bolts (1/4-20 x 1/2 in.) into

slot in back of rear rail of your table saw and rear extension

rail.

 Space bolts along rails as needed to accomodate rear

extension table.

 Attach remaining four table brackets to rails and secure

with washers (1/4 in.) and hex nuts (1/4 in.) provided.

 Hand tighten hex nuts.

REAR EXTENSION TABLE TOP (not supplied)

See Figure 11.

We suggest you cut a piece of plywood 82 in. long by 3/4

in. thick. As previously mentioned the width should be

determined according to application requirements and

individual preferences. Two slots should be cut in the plywood

as shown in gure 11. These slots will permit sliding miter

table to continue to be used as it was designed. Slots must

be cut large enough to permit full travel of sliding miter table,

so as not to lose its versatility.

 Place rear extension table top in desired position on table

brackets and adjust table brackets as needed.

 Tighten the (four) hex nuts securely.

 Secure rear extension table top with wood screws (#10 x

5/8 in.) provided. See Figure 8.

NOTE: These screws mount from underneath table top the

same way auxiliary table top mounts to table brackets.

TABLE LEGS (not supplied)

See Figure 8.

Table legs (four) for the rear extension table should be

constructed. Construct them similar to methods explained

for making table legs for auxiliary extension table. Either

2 x 4s or Ryobi Leg Set, # 4730305 can be used.

A piece of 2 x 4 for securing table legs would need to be

mounted on bottom of rear extension table. It should be

located close to the end of rear extension table.

If extra bracing is needed, cut pieces of scrap wood and

attach to bottom of table legs. See Figure 11.

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Ryobi BT300 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi BT300