Ryobi BTS20 Manuel d'utilisateur télécharger pdf (Page 15)

Page 15

ASSEMBLY

OPENING THE LEG STAND

See Figure 10.

Note: You can also refer to the blue label on the right-hand

side of the table saw for setup procedures.

 Standing to the side of the table saw, use your left hand

to pull the leg stand latch towards you.

See 1.

 Once the leg stand is released from the table saw base,

ease the legs of the leg stand toward the floor.

See 2

 Grasp the grip firmly with your right hand. Keeping your

left hand clear of the leg stand, pull the leg stand up until

it locks into place.

See 3 and 4.

 With your left hand firmly on the table tilt handle, grasp the

grip with your right hand.

See 5.

 Push the leg stand towards the ground with your right

hand and pull in the same direction with your left hand

until the table saw is in an upright position.

See 6 and 7.

Fig. 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Pas de commentaire

Ryobi BTS20 Manuel d'utilisateur Page 15