Ryobi CSB123 Manuel d'utilisateur télécharger pdf (Page 9)

9 - English

 Retract the lower blade guard into the upper blade guard

using the lower blade guard handle. Make sure the lower

guard spring works properly, allowing the guard to move

freely.

 Check to see that the saw teeth and arrow on the saw

blade and the arrow on the upper guard are pointing in

the same direction.

NOTE: The saw teeth point upward at the front of the saw

as shown.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

 Replace “D” washer.

 Replace spring washer with cupped side against “D”

washer.

 Depress spindle lock button and replace blade screw.

 Tighten blade screw securely by turning it clockwise with

the blade wrench.

NOTE: Never use a blade that is too thick to allow the

“D” washer to engage with the flat on the spindle.

REMOVING BLADE

See Figures 2 - 4, pages 15 and 16.

Unplug the saw.

Depress and hold spindle lock button.

Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

Remove spring washer and outer blade washer (“D”

washer).

Lift lower blade guard.

Remove blade.

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

starting and possible serious personal injury.

WARNING:

A 7-1/4 in. blade is the maximum blade capacity of the

saw. Also, never use a blade that is too thick to allow

outer blade washer to engage with the flat on the spindle.

Larger blades will come in contact with the blade guards,

while thicker blades will prevent blade screw from se-

curing blade on spindle. Either of these situations could

result in a serious accident.

CAUTION:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

ATTACHING BLADE

See Figures 2 - 4, pages 15 and 16.

 Unplug the saw.

 Depress and hold spindle lock button.

 Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

 Remove spring washer and outer blade washer (“D”

washer).

 Wipe a drop of oil onto the inner flange bushing and outer

blade washer (“D” washer) where they contact blade.

WARNING:

If inner flange bushing has been removed, replace it be-

fore placing blade on spindle. Failure to do so will prevent

blade from tightening properly and could result in serious

personal injury.

ASSEMBLY

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB123 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi CSB123